Audi b2 coupe quattro 10vt vems

[bn-01-wso]

Kessu what cam are you using? you also use springs and retainers or just the cam? thanks

[kessu74]

Catcams turbo camshaft,schrick springs,original retainers.

[bn-01-wso]

Kessu what boost pressure are you running for that power. I also bought a 283 / 274° cam from catcams and i am in the process of rebuilding the engine. Thanks alot.

[kessu74]

Redline 1.8bar

[bn-01-wso]

wow. Some serious power with 1.8. I was thinking about 2bar. I'm hoping i'll get around 400 also. Thank you

[bn-01-wso]

I finally managed to rebuild the engine and get it maped by Kulinpapa one of the best Vems tuners. Is working on 1.5bar pressure. I am curious about the power output but i don't have a dyno in my area.

[bn-01-wso]

And a video. Sorry about the lenght of it

https://www.youtube.com/watch?v=EPkOy05r10I

[quattro-nick]

Always nice when you see an audi b2 coupe quattro project

[bn-01-wso]

Received my new clutch today after 2 months. Can't wait to mount it and see how it launches with the 01E gearbox. I had some trouble with 016, i couldn't lock the center diff and looked like i had FWD

[diesel des]

Who made the clutch? Is that a custom flywheel too? Nice project .

[bn-01-wso]

Who made the clutch? Is that a custom flywheel too? Nice project .

Thanks
Clutch was made in Hungary with new custom flywheel. It is a reconditioned 2 disk Tilton. I am waiting to see how hard it will to drive it. Never been to gym before so no leg days

[diesel des]

It should grip hard! May not be as hard to push as you think. I'm trying to get an organic 2 plate clutch made for my urs4 to make city driving easier than a single sintered Sachs unit. Could you measure from flywheel face to pressure plate point were the release bearing touches for me please. I am wondering what the stack height is.

[bn-01-wso]

It should grip hard! May not be as hard to push as you think. I'm trying to get an organic 2 plate clutch made for my urs4 to make city driving easier than a single sintered Sachs unit. Could you measure from flywheel face to pressure plate point were the release bearing touches for me please. I am wondering what the stack height is.

That is about 43mm if i am not wrong. Pressure plate is not tighten. Is the same pressure plate as the triple disck

[diesel des]

Ok l and what thickness is the flywheel from the crank flange to the friction surface.

[bn-01-wso]

Ok l and what thickness is the flywheel from the crank flange to the friction surface.

From what i've measured is 28mm