From Audi 100 to urS4 in a week

[Dift]

Any rust? I'm on the hunt for two wings ideally.

[igor136]

Wow, nice one

[UrS4boy]

Any rust? I'm on the hunt for two wings ideally.

Dude: It's not dead yet.

[Dift]

Dude: It's not dead yet.

promise I didn't mean it like that!

I'd never encourage anyone to break a car... No matter how much I wanted some parts.

[hunker7]

Not going to break it, even if it means loosing money. But it is in a good nick, so I am keeping this for sure.

[Vorsprung durch Technik]

Looks Very nice Janis and good for less than a bag of sand.

Hope you manage to get it started tomorrow.

Oh buy the way.....remind me not to believe you when you say your skint.



Got to hand it you though!!

[hunker7]

Looks Very nice Janis and good for less than a bag of sand.

Hope you manage to get it started tomorrow.

Oh buy the way.....remind me not to believe you when you say your skint.



Got to hand it you though!!

I will be surprised if I get it running tomorrow, don't think it'll be that simple, but fingers crossed

I got my uni bursary so I just thought "why not"?

[Vorsprung durch Technik]

I hope it goes well for you and you come out smelling of roses with this one.

I like the colour too.

[hunker7]

I hope it goes well for you and you come out smelling of roses with this one.

I like the colour too.

Will update tomorrow

[hunker7]

So this thing was connected to aftermarket relay. The green/brown wire is now loose, don't know where it should be connected. Any help appreciated.



I got the starter motor to crank by putting 12v straight to it, so it's not getting a 12v signal from the ignition. Does anyone know which wire goes to starter motor?


One of the fuel lines are leaking badly Might tow it to the local garage to get that done as it's hard to do on the ground

[quattrostyle]

It is doable to replace (a piece of) the fuel line without a post lift. BTDT with one of my cars.

[hunker7]

I guess I could replace them with rubber ones for now so I can run it and MOT it.

[andy10v]

You can replace the fuel lines with rubber or cunifer on axle stands just fine, will save you some money, especially if you just want to get it running/in for an MOT to see what the car is like.

[hunker7]

Managed to remove the old fuel lines, literally fell apart once I started moving them, bought some 7.5 meter 8mm fuel hose and some fuel line clips, but didn't get it fitted because it started raining.

Got all day Tuesday off, so will crack on with it then. Otherwise underbody is pretty straight apart from some surface rust, but nothing serious.

[geneandbolly]

None of your photos are showing up.

And by "none" I mean NONE. Not just this recent post. ALL your posts. Ever.

for once, you're actually wrong about something, prof! they show up fine this end. perhaps the snow is fogging your vision over there??!