VEMS I5 Maps

[A80Avant]

Mine does that as well but has no implication to the engine. Its just a small glitch of vems. Fueling and engine works fine so its just psychological. I'm not worried

sent with Nokia 6210

[blackS2]

We are on 1.1.96 yet... the cars running fine... but sometimes the 6500 rpm sh** on the Audi Trigger car

my friends are using the 60-2 VW Trigger... but I'm to lazy to take the gearbox out

[A80Avant]

Yep, or you could use an "official" firmware
1.2.2 was very good when I tested it on my car

Yes do what Jamo says. His car always ran wonderfully on vems

sent with Nokia 6210

[Jamo]

Use 1.2.2 firmware

Yep, or you could use an "official" firmware
1.2.2 was very good when I tested it on my car

[blackS2]

Use 1.2.2 firmware

Ok I see what you talking about..

http://www.vems.hu/wiki/index.php?page=GenBoard%2FUnderDevelopment%2FFirmwareChanges

[Biturbo]

Use 1.2.2 firmware

[blackS2]

This is my trigger settings.And sensor come closer about 0.5mm

thx, this is an interesting setup... I've never seen this before... (I use diveby3) and have also triggor errors sometimes at 6500... I've to fix that

[Biturbo]

can you please post a screenshot of your Primary Trigger Settings Menü

This is my trigger settings.And sensor come closer about 0.5mm

[blackS2]

I don't no that is diffrernce but on my car divbyN9 not working and 27 is perfect

can you please post a screenshot of your Primary Trigger Settings Menü

[Biturbo]

what is the difference between divbyN 9 and 27??

I don't no that is diffrernce but on my car divbyN9 not working and 27 is perfect

[murat]

what is the difference between divbyN 9 and 27??

[Biturbo]

I think your solution was the sensor coming closer, not the 1.2.2 firmware.

Others have used the same firmware and still get Trigger errors

sent using the force

Posible ,but firmware 1.2.2 is done for audi trigger errors.Now will wait from vems then sort knock detect and I think is will be soon

[A80Avant]

I think your solution was the sensor coming closer, not the 1.2.2 firmware.

Others have used the same firmware and still get Trigger errors

sent using the force

[Biturbo]

what rpm range were you getting trigger errors??

Around 6000rpm,I was using 1.2.0.Now sensor is closer and 1.2.2 and no more errors

[cooperquattro]

what rpm range were you getting trigger errors??