Coding plug T6d......

[audiman]

Where the hell would I find this?!?!? I cannot find the plug at all. Need to wire in a clutch pedal switch into pin 39 of the ABY ecu. I could just solder into the ECU plug end of the loom, but thought I would try and keep it neat.

[newsh]

What’s the clutch switch for Tom?

[audiman]

Making fire come out the exhaust

[audiman]

Will be putting the Sachs race clutch to the test using launch and no lift shift

[newsh]

Crikey!

[Error404]

You should find it near the ECU / barometric pressure sensor, it's 6 pin black.
Looks like this:

893971833.jpg

What ECU / software are you using with flatshift Tom?
Just FYI, calibrating/setting the clutch switch position is important so using a generic flat-shift or launch strategy will take some fiddling to make it work correctly.

[audiman]

Nothing generic with this! It’s being custom tuned on Saturday I hope

[audiman]

Must be behind the little kick panel on the left of the car. It’s not by the ECU. I have to take that off anyway to remove the procon 10 cables and some old alarm wiring

[SteveH]

Is Mik using a 12v feed from the clutch switch for flat shift?

[Tractor Dave]

Must be behind the little kick panel on the left of the car. It’s not by the ECU. I have to take that off anyway to remove the procon 10 cables and some old alarm wiring

Yes, it is. Everything in bits with me and its there on the left hanging down.

[audiman]

Is Mik using a 12v feed from the clutch switch for flat shift?

might be

[SteveH]

Nice