Now i have followed the Blue/blackcable ,, F22.
The problem is. When i set the multimeter at the connector that that goes on the oil sensor , the big one , and on the other end where the white arrow is on picture 2 i get connection,buzzer.
Now look at the video when i try to use my cable finder to check the wire from that connector and back. It does not react. And then i connected the wire finder to another pin ,, that is how it should work/sound. So why does it not sound ? Its not a bad connection inside the connector ,, then it would not ping with the multimeter.
Video .... https://www.youtube.com/watch?v=Wbxi...b_channel=LjTo
The cable finder has 2 cables , one to ground and one to the pin.
Hmm ,, just did another test ,, i kept the ground at sam spot and the other cable on the cable finder ,, i put on the connector in the engine bay that goes to oil sender ,, and whne i try to search under tha dashboard it finds it..
Soo... there must be some issue in the connector some way.
The multimeter pings it ,, but not finder, Is it possible that the multimeter pings but there is where little connection inside the connector ???
Can i measure somehow if the connector with the multimeter before i dissassemble it ???
Best Regards
The problem is. When i set the multimeter at the connector that that goes on the oil sensor , the big one , and on the other end where the white arrow is on picture 2 i get connection,buzzer.
Now look at the video when i try to use my cable finder to check the wire from that connector and back. It does not react. And then i connected the wire finder to another pin ,, that is how it should work/sound. So why does it not sound ? Its not a bad connection inside the connector ,, then it would not ping with the multimeter.
Video .... https://www.youtube.com/watch?v=Wbxi...b_channel=LjTo
The cable finder has 2 cables , one to ground and one to the pin.
Hmm ,, just did another test ,, i kept the ground at sam spot and the other cable on the cable finder ,, i put on the connector in the engine bay that goes to oil sender ,, and whne i try to search under tha dashboard it finds it..
Soo... there must be some issue in the connector some way.
The multimeter pings it ,, but not finder, Is it possible that the multimeter pings but there is where little connection inside the connector ???
Can i measure somehow if the connector with the multimeter before i dissassemble it ???
Best Regards
Comment