Volvo K24 turbo in audi application.

[andy10v]

Tired?
I had all rings, all bearings etc changed a year ago...
No, my engine was not tired.

Will take off the pan, cut the filter and see wtf...

That is sad to hear, hope you get a relatively straightforward fix.

What is the plan for the engine then? Or will you decide when you get it apart?

[andy10v]

that is quite steep, i paid $50 shipped for the one on the turbo that dimtri showed.

Can you remember who the courier was?

[Error404]

bearings spin because of insufficient crush so you need to get your big end bores or mains resized

[prj]

Sounds like you should have put the k24 on instead.

Would have happened sooner or later anyway...
This is no way the limitation of the stock engine, bad mapping or knock.

[prj]

so then,why the bearing failed??

did you heard some extrange metallic noise from the engine before the fail?

Because the guys who rebuilt my engine probably re-used the rod bolts and did not measure it over.
Just a theory.

Log on the last run, when oil pressure went, with very low timing:

[Rocco]

so then,why the bearing failed??

did you heard some extrange metallic noise from the engine before the fail?

[Ruffiano]

Sounds like you should have put the k24 on instead.

[Thuppu]

Yes, remember you told something about engine rebuild in your show thread...

[prj]

the mapping

now really, i am sorry to read this. your engine should was tired....

now put,new piston rings, all new bearings and Aron rods ,and go hard with it

Tired?
I had all rings, all bearings etc changed a year ago...
No, my engine was not tired.

Will take off the pan, cut the filter and see wtf...

[Rocco]

the mapping

now really, i am sorry to read this. your engine should was tired....

now put,new piston rings, all new bearings and Aron rods ,and go hard with it

[Thuppu]

Sorry to hear that.

[prj]

Just spun a bearing, so not getting anywhere.
****** rebuild job...

[Ross]

How are you getting on with that K26/7?

[prj]

we want numbers!

So do I...
But when you tune 1-2 cars every week, you have no time for your own

For now the K26/K27 is going onto my car (tomorrow) and the K24-7400 is getting modified to fit.

[Ruffiano]

I am getting closer, still trying to get a exhaust housing, found one in the states for an ok price and $100 dollars shipping

that is quite steep, i paid $50 shipped for the one on the turbo that dimtri showed.