Stroker cambelt guide

[AndyP]

Perfect thread Andy , can u reupload the pictures?Photobucket seems to have some "problem"

Thanks lot

Tom

Photobucket has banned 3rd party linking so the 1300photo's I had on there are all broken now

I'll fix them eventually, but it'll take some time.

[Tom_]

So much good pictures, its bad to hear

[Tom_]

AndyP Hi Andy, what about pictures?Anything new? Thanks

[sailaz]

Custom tensioner

What you mean 'custom tensioner' ? You did custom work on it or what ? What is part number of it ?

And what about fitting fluiddamper ? Is it 034 ? Did you have to do any custom work on that one ?

[Tom_]

AndyP Andy, can u please send me your pictures of Cambelt solution? I upload them and send here links. Now i am choosing cambelt solution, so i want to be 100% sure that will be right

[newsh]

Saw this on another forum

If you're using Google Chrome, go to the three dots on the right side of the screen and click them. A drop down should appear. Hover your mouse over "More Tools," and when the next drop down appears, click on extensions. Go to the link towards the bottom that says "Get more extensions." In the search box, type "Photobucket Fix," and hit enter. Click the install button and once it's done, you should be able to see photobucket pictures again.



For FireFox users, click on the three bars on the right side of the screen, then click on add ons. Click search for "photobucket hotlink" and click install. Same result.

[Thuppu]

Good tip, thx.

[Tom_]

Like a boss , thanks lot mate, very good tip

[Thuppu]

And seems to work nicely!

[Tom_]

Guys, just quick thought...If i use a ADU belt (034 109 119C) with 3B oil pump + 3B water pump as the belt tensioner...It should be everything fine with no mods and no problems with grinding inside block due water pump as had AndyP with ABY belt ..What u think? Thanks

[Tom_]

Here's what I thought to use for my stroker; Supertorque S8M-1200. Correct tooth pitch, 150 teeth, 20mm wide and only $38.40usd. Correct me if i'm wrong

jsol Maybe this is solution too, but i am not sure if wide 20mm will be not problem and how quality is those belts...

[diesel des]

I used the 3b water pump and aby belt with a slave made to fit over the idler to make its diameter larger. Works well on both strikers and it's easy to get the water pumps, and belts. Using the aby tensioner means drilling into water ways near the cylinder and I didn't like that.

You can find off the bulge at the front of a 3b water pump easily if clearance is required.

Sent from my Moto G (5) using Tapatalk

[jsol]

jsol Maybe this is solution too, but i am not sure if wide 20mm will be not problem and how quality is those belts...

The belts are quality. Jeff Gerner uses them at FRP.

[jsol]

Here

http://12v.org/frp/7-dry_sump_pump.jpg

[jsol]

Page 37

http://www.goodyearrubberproducts.com/2010newpdfs/Goodyear%20PTP%20Full%20Line%20Catalog%202010.pdf