Those who run LPG converted 2.2's

[hunker7]

I'll get it done tomorrow

[hunker7]

Level sensor isn't working still, I have to calibrate it, but how do I know voltage does sensor read at each quarter tank? Do I just record full tank, then empty tank and decide by 4?

[diesel des]

You could measure the resistance as you drive. So use your odometer to note resistance as the miles goes on and the tank empties. Then calibrate the ecu to suit.

Sent from my LG-H955 using Tapatalk

[hunker7]

Works on voltage. It should be linear so I'll try empty tank voltage and full tank voltage (easier ) and if that doesn't work then I'll hook up multimeter on one of the trips or laptop that'll happen when it's all calibrated correctly though

[hunker7]

Did 3 reading for each speed/gear

[diesel des]

So you need to enrich the gas at 4 ms quite a bit.

Sent from my LG-H955 using Tapatalk

[hunker7]

So which points on the graph I'm moving about?

[diesel des]

Move the point that's at 5.8 to the left to about 4 and also drag it up some to about 6 on the y axis.

Bring the point at 7.1 to the left to about 6 and bring it up slightly on the y axis to about 7.5.

Sent from my LG-H955 using Tapatalk

[hunker7]

This is what I have atm.

[diesel des]

Ok re run your tests at different speeds noting the motronic Times on petrol and gas.

Sent from my LG-H955 using Tapatalk

[hunker7]

Ok re run your tests at different speeds noting the motronic Times on petrol and gas.

Sent from my LG-H955 using Tapatalk

I will do that tomorrow night, as that is the only time I can get a good run in on M621

So I looked at the level gauge, and it always reads 4.6v? But I assume it should be decreasing as calibration uses voltage?

[diesel des]

Sounds like your level gauge might be faulty or wires wrong some how. Check with the suplier what it's characteristics should be.

Sent from my LG-H955 using Tapatalk

[hunker7]

Sounds like your level gauge might be faulty or wires wrong some how. Check with the suplier what it's characteristics should be.

Sent from my LG-H955 using Tapatalk

There are only 2 wires to the solenoid and you can't really connect them incorrectly. I will drop them an email and see what they say.

[kibby]

Gauges are always faulty never accurate I can run 100 miles and three of the for lights go out and on the last one I get 150 miles

[diesel des]

The gauges aren't great I agree but I have mine set to turn a light. Off every 50 miles or so.

Sent from my LG-H955 using Tapatalk