Audi S2 front shocks.Need info and absorbers.

[rxl]

in your place i would ditch the s2 stuff and go for kw suspension.
the old one s2 stuff goes like 250 euro and if you put new dampers and springs to lower it it will cost you almoast the same if you just buy kw and sell the other stuff. and kw stuff does not rost and looks like a porn

[ristokru]

Thanks for help. In future i will but KW stuff but right now i only need front dampers. Is there some dampers that dosent cost over 300 euros? Just now i need money to other things.
I have to put new top mounts also and it would be good if i can change all together.

[Colesy]

I ran H&R lowering springs with Bilstein B6 shockers and it was a terrible combination as said above. Too harsh a ride and too low for the roads around here. I have also heard that Konis and the H&Rs are a good combo but don't know for sure.

I put the original springs back on with the Bilstein B6 shockers and have found this to be a great setup. I've run it for around 6 years and wouldn't consider changing it.

[newsh]

Some B4s here
https://www.ebay.co.uk/itm/122165365415

I got my B6s for the avant from this seller. I run them with stock springs and it's perfect.

[ristokru]

Some B4s here
https://www.ebay.co.uk/itm/122165365415

I got my B6s for the avant from this seller. I run them with stock springs and it's perfect.

Thank you very much for help! But S2 Outer Diameter is 55mm.


B4s info:

Audi 80 Avant (8C, B4) S2 Quattro (169 kW)
Years of manufacture: 02/93 > 07/95

Suits Models with a Power Level of 169 kW. This equates to approximately 227 BHP
Outer diameter [mm] 50

[newsh]

Thank you very much for help! But S2 Outer Diameter is 55mm.


B4s info:

Audi 80 Avant (8C, B4) S2 Quattro (169 kW)
Years of manufacture: 02/93 > 07/95

Suits Models with a Power Level of 169 kW. This equates to approximately 227 BHP
Outer diameter [mm] 50

Hmm, strange