Clutch release / throw out bearing

[macspring]

Thanks, who did you buy it from, cost, link ?

Thanks again.

Am I right to presume this thread effectively applies to the UrS6 also and not just the B4 S2/RS2 ?

[A80Avant]

I bought it from the original link on this thread. I use a 7A flywheel and clutch kit and I think the bearings are the same if you use a dual mass as well.

Use the helix link. I bought 2 as well to make sure I have a spare.

[yodasfro]

That one looks slightly different any chance at some more pics and one of the label on the box? Were all the ones you ordered the same?

[A80Avant]

Both of them the same from helix. I'll try and dig the box of the spare one

[A80Avant]

Hmm apparently they are not the same. uploadfromtaptalk1428752796031.jpg

But it's weird as if I put the part number of luk on the Web amazon comes up and has a photo of the one above here. Obviously the 2 are different

[popdemonic]

i heard some rattle noise off the Sachs throw out bearing.it came up with the Southbend clutch i had purchased in 2011.
soon i 'll be pulling off the gearbox again.it might be a good time to replace 10quids parts.i checked on the Helix and it's now NLA on
INA Bearing.what's the second source?

[A80Avant]

Amazon has the one above if you search with the part number above

[Rusty]

What s the part number, Vas?

[LHD_Kid]

I bought one from Helix, immediately afterwards, as per their site they have no more in stock... can this be right??

Mine arrived so perhaps I had the last one?

[rxl]

mahle is also metal one

[A80Avant]

500041010

[A80Avant]

What's the mahle part number?

[popdemonic]

Vas,
500041010 is also using in Ford?
i found many listings on ebay.

[A80Avant]

Yes apparently so

[popdemonic]

well,I'm going to order 5000 41010 for my UrS6 dual mass flywheel then.