Wagner Inlet Install Questions

[EMU_S2]

just found out yesterday wen i wend out to take a look at the parts im gonna buy that it is a real wagner intake. im having a friend of mine alloy weld a flange on for the idle stab engine. now my new question. how about going blow through maf? i saw earlier in the thread somebody did so. what piping should i úse for the maf that could withstand the boost? will i be able to run BOV'less with a blow through? and are there any disadvantages to blow through on a 3b compared to a Draw through stock setup?

[newsh]

Were we talking on FB about this? If so I think the IM you were looking at came without the hoses. I was having a sort out in the garage and came across some parts.

I have a blow through MAF alloy tube setup and a silicon hose to fit the Wagner IM with the branch for the ISV. I will sell them if you're interested. They were running on S2 Bo's car.

John

[EMU_S2]

id be interrested in the MAF pipe. the hosing i allready got. and indeed. in Christopher on FB. PM me in there if ya like. im faster responding on the phone.

[EMU_S2]

is it one like this you refer to?

http://www.kf-z.de/ebay/wastegate_audi/lmm.jpg

[andy10v]

I would be interested in the hose if S2MTMFAN does not want it? (wagner intake on its way)

Has anybody thought of getting a small batch of RHD S2 wagner throttle cables made up?

[newsh]

is it one like this you refer to?

http://www.kf-z.de/ebay/wastegate_audi/lmm.jpg

Similar, I'll put a pic up later.

[newsh]

I would be interested in the hose if S2MTMFAN does not want it? (wagner intake on its way)

Has anybody thought of getting a small batch of RHD S2 wagner throttle cables made up?

Yes, I was thinking of going to Venhill in Dorking but it means taking the cable off the car and the dash is back in now..

[newsh]

I'll post a pic of the hose too.

[newsh]

Here ya go boys. 20 quid for the hose, it will need extending with a straight bit to reach the IC as it was shortened to fit the MAF.

30quid for the blow though MAF tube complete with working MAF!

Both plus postage (about 7 quid?)

[andy10v]

I will take both if S2MTM fan does not want them first.

[newsh]

Ok bud, I'll PM him

[EMU_S2]

First of all. thanks for the trade Newsh! lovely piece of pipe.

secondly. im running a 3B engine. anybody got a link for the V-belt for the PASP that would be needed? i saw one on a earlier page. but thats 13mm wide. where as the 3B as far as i know is 10mm??

[newsh]

Look in my coupe project thread, there's a part number for the belt.

[newsh]

3B Power Steering Belt



Finally a belt that works perfectly on the 3B with the Wagner Reverse Inlet Manifold! Hopefully this will put an end to all the screeching and flapping noises from the front end! Thanks to Pete at White Cottage Quattros!

Here you go

[EMU_S2]

Thats the one i looked up on the internet. It seemed to be 925 in lenght and 13 in width.