Building a S2 mk2 golf

[4WheelDrifter]

Oops.

Good looking welds on that plenum. Good_looking_ design, let's just keep our fingers crossed, that it won't explode in first testdrives.

[gnutz2]

The old IM just went like a balloon, not very impressive just round, it also bent the throttle plate which i had to straighten out as well as blowing off all silicon hoses attached to the manifold. As i said it ws a big backfire

Im also having problems with cooling, the naca duct just are not enough to cool the engine, it runs about 95-100.

I think the power is well over 300hp running 14 psi, but the ignition advance is very safe until i get it set up. Looking at the 35R copressor map i can run about 2.2 bar with no pressure drop across the charge cooler so maybe a bit less.

[Acidburn]

any pictures of what the old im looked like.

whats it go like whilst your running it in?

[gnutz2]

Thanks guys,

I was sorting out the fuel the other day and running the engine in too, i was running about 14 psi of boost and had an unbeleivable back fire which turned the IM into a balloon, so this gave me a chance to make one that fits under the bonnet, i took the ABY IM and cut in two, cut out the service ports and mounted my TB and the extra injectors in it.

Also the cars going for mapping on tuesday so i should have some idea of power output

[europeanme]

killer sound or what.....even mine doesn't sound like that.....

[macspring]

I know it might sound repetitious at this stage, but well done that man.

Hope to see it at a Show in the future and looking forward to seeing any vids of it at say GTI or whenever it's ready.

Best wishes with it, it is a great idea brought to life.

[aelred]

I take my hat off to you!!

[4WheelDrifter]

Yeah. Excellent work Raz. See you at GTI.

[s2_bo]

Nice work Gaz! am loving that sound cant wait to see this one finnished!

[john@rallye]

Very impressive work!!!

[G60Rallye]

Totally awesome mate!

Cannot wait to see it flying up the drag strip and around some tracks!

[gnutz2]

Yeah, i was priming the charge cooler, i have to remove it and turn it on its side to pour water into the end fitting and make sure there`s no trapped air, PITA

[Rusty]

Sounds good, be nice to hear it running when you get the turbo and inlet piping all back on there... hope to see this in action this summer

[gnutz2]

Short Vid of the engine running

I took it to my mates work in middlesbrough to make the exhaust and i cannot belive how sweet the engine sounds and its not too loud with a 3.5" system and two small jetex boxes.

[europeanme]

it's been said before....and will probably be said again.....what an awesome project!!
such attention to detail....and craftsmanship.....you sure are a credit to anyone who loves their garage/shed/workshop!!!....

keep up the good work.....