Billman - about how much did it cost to have the machining done, or did you do it yourself? I have a k26 kicking around and I bought a Holset WH1C from ebay over the summer and intend to combine the two. I guess I'm just looking for some helpful hints as well. Thanks! Looks great so far
Announcement
Collapse
No announcement yet.
Another "Stroker" Project
Collapse
X
-
-
exactly my concern - my knowledge of machining is sadly limited, but I have a class coming up which will help things. How was the curvature followed? Special milling tool head, or what?_____________________________________
1991 Audi 200 20v - GT35
1996 Audi Cabriolet 5 speed swap
2003 Audi A4 1.8T quattro 5 speed
Comment
-
I started the Car today on VEMS. I havent installed the WB-Lambda and the EGT yet but idle was smooth somewhere at 850 RPM and with out load it revved till 6500 very smooth.
I heard that maybe the maybe the idle would not be so good ect before but it is actually very good. Without load and with this crap tuning for my car it was i dare to say at least as smooth as motronic.
I will comment on it further when i get there...
I hope tomorrow to install the WB and EGT so i can actually monitor everything.Go Holset or Go RS4
Comment
-
Here is a small crap clip i made with the mobile. It is the very first start on VEMS.
http://www.youtube.com/watch?v=7nKIeTfZyawGo Holset or Go RS4
Comment
-
Great! I am also following your personal VEMS page:
http://www.vems.hu/wiki/index.php?pa...Page%2FBillman
Comment
Comment