Audi S4 small drag project

[vcosmin]

Atm, i used an electromagnet solenoid switch that pull the throttle cable but not strong enough.
Price wise the dsg and 4eat gearbox prices are the same, http://www.adrenalintuning.de/ has a custom controller. is used here, in the 16v vampire

http://www.youtube.com/watch?v=vxG1PFHOpI8

(note the electronic clutch )
Also the 4eat (from Subaru) handles 1000hp, easily, if is build right here, is almost stock gearbox. and only 640hp.

http://www.youtube.com/watch?v=-AI7CgjbWwU

There are many companies in USA, or AU , that build 4eat, best is Rigolli, but expensive.

[|CL|NIKI]

Yes - I saw that Boba goes with DSG, but why....?
Keep the progress mate and good luck.

[bartolomeus]

Can you share the prices, I couldn't find any price on the links you provided...

[vcosmin]

If you mean gearboxes ? prices around 6000e

[bartolomeus]

Yes the prices for the gearboxes. Ouch... 6000 EURO...

[vcosmin]

http://www.youtube.com/watch?v=PhVzI4zfcCM

[vcosmin]

New exhaust on my DD Original vs Custom. 2x2.5
It sounds ok, no drone over 3000rpm, or under 2000rpm - but between 2000-3000rpm i get some drone - any tips for avoiding this ?

[Costash]

A different back box is what you need ,I been having same problem but my old chambered back box Avantus saved me from drone.

[vcosmin]

After a long break - new turbo 67.7mm billet BorgWarner Airwers S400SX3 and new nuke performance blowoff.
Will use a 25% TPS ALS, small stuff to adjust and new settings :-)

[bartolomeus]

Nice seeing you active again

[vcosmin]

And is here - much biger than older units (like physically bigger and heavier) - hope to be reliable and give some decent number - 850hp is target

https://scontent-fra3-1.xx.fbcdn.net...c5&oe=5609F694

:-)

[speeding-g60]

works for me here :-)

[vcosmin]

And after a very , very long time the car started - with e85 stored for about 7 years. Some new parts are here
tial.jpg nuke.jpg tialnew.jpg

[vcosmin]

Also, the car will get back to street layout, that means probably a 80 competition design. And last but the most important part, some guys from poland are using a built 5HPFLA gearbox that take 1000hp, and 1000nm with a TCU Ecu i am wondering if this gearbox would fit b4 chasis ?