Terrybullwon's Racing S2 coupe

[gnutz2]

love the see your developing this already great car, the bolt on aluminium front end is a smart idea, have you retained the snub mount or is it omitted?

It would be great if the intercooler was moved from the front axle too, maybe a chargecooler in the passenger seat location and the pre rad in the boot would get more weight rearward.

Anyway great work

[terrybullwon]

Looks cool.

Is the front wishbone mount higher than the rear wishbone mount? If so why.

Are the extra cam belt rollers to stop the belt flapping?

Better wish bone angles, alittle added rack. But it will be set at oem for now until it can be tested.

Yes two extra belt wheels

[andy10v]

Looks cool.

Is the front wishbone mount higher than the rear wishbone mount? If so why.

Are the extra cam belt rollers to stop the belt flapping?

[newsh]

Approved!

[dubmanted]

Fantastic work it really is

[mac2226]

Looking good james

[terrybullwon]

Almost there now. Just a few little bits left to do.

Aluminium frame under way to take wings, bumper, lights, oil cooler, wagner intercooler and a few other bits. I ordered a sheet of aluminium honey comb for the flat floor which i need a very large sheet of glass to lay up the carbon onto.

New pedal box is here so i'll have that in before i trailer it up to J-Tech to stick a set up on it. Corner weights should be spot on now.

[AndyP]

Welded top mounts, not to bad considering i was at the christmas staff party the night before

Nice work

[terrybullwon]

James what ratio are you turning that pump?
3:1?

Its 57% of engine speed i'll have a count up if i remember

What advert?

Cheers buddy


Thanks to Jay @ DM Developments for the conical weld in mounts for my aluminium front frame they are 870 grms for all 4. So hardly pushing the boat out. Also knocked me out some wishbone brackets so i could finish the front end and fully weld up.



Welded in at the lowest point, this will take the wagner intercooler and flat floor.



As you can see the frame is pretty much done now and will be ready for set up and paint in Jan. Top mount angle perpendicular to strut is extreme as it looks in the photo

[A1QSHIP]

What advert?

[Jamo]

What advert?

[GazzaG60]

wow your engine holder looks like mine except mines steel and made by rover

lol for the chancer with the advert

[terrybullwon]

Dude are you advertising in my project thread???

This stuff is all home made.

[Wizard-of-OD]

Money shot......

James what ratio are you turning that pump?
3:1?

[terrybullwon]

What does that work out to cost per kilogram?

I stopped adding up what I spend on it along time ago..