Terrybullwon's Racing S2 coupe

[terrybullwon]

Well.... time for a update.

Work has been taking all my time up but i do have a nice chunk of over time to spend
(Read all ready spent)

This sunny spell is what i am blaming on all the extra hours i have put in. Springs not due till after easter imho.

None the less i have been chipping away.

I am really now just waiting on AST and Selholm and a day or so to work on the last parts of wiring and i can run it again.

Dry sump system work has commenced. I'll pull the motor out and try and get that done in a day i hope as i promised JP my coated pump.

Some pictures

Pedal box done, balance bar connected, resiviours, remote adjuster connected just need to connect a micro switch for the launch control


Fans connected up works like a train!




Control panel still needs work





I'll fit the harness's last as its tight in a coupe to work around the cage as it is



Need some large cable ties to sort this mess out and a meter length of tube for the fuel inlet



From the other side



Motor with water lines



Turbo with down pipe (money shot)

[Rocco]

unbeliable projet James

are you doing everything yourself?

[terrybullwon]

Yes Rocco thats why it takes so long!

Dash..... says

[Rocco]

and then, will you expect to go for the MRC meeting weekend? with your pearl white ride of course¡¡

[terrybullwon]

Life line

[terrybullwon]

and then, will you expect to go for the MRC meeting weekend? with your pearl white ride of course¡¡

Working i am afraid i already tried to pull some strings but no luck yet

[Jonnybravo]

Looking good James, out of interest why are you running the fuel level and pressure gauge when the dash can support that ?

[anthonys2]

Thats some piece of kit you have built up there!!! great job mate

[terrybullwon]

Cheers!

James I got your pm I'll give you a reply later.

But to simply reply,

The dash supports only 4 0-12v inputs and my ecu is not compatible
With it so I am going to put in analoguely

Wide band
Oil pressure
Oil temp
Water temp

And then it's already to go with speed signal from the ABS sensors and revs from the ecu signal out

[Jonnybravo]

Thanks for that, I'm going to dig the manual out now, I'm streaming what I can from the ecu but obviously just need a few normal sensors. I think the only backup I'll use is the boost guage incase the map sensor has a moment to itself.

Great work though as ever.

[pnanassy]

fortunately my m600 motec talks to my rt dash2,sends 25+ channels which is great!(more than the rt can show in one configuration)

i also developed a small fuel prediction unit,that uses the motec fuel used signal,and generates a fuel tank level signal.handy because lpg fuel tanks dont have good working level senders.

[s2_bo]

Amazing James! It looking better every time..

[RustyNut]

Great work there James. Is your passion self taught or did you study mechanics?

[terrybullwon]

Great work there James. Is your passion self taught or did you study mechanics?

I was ment to go to uni to study engineering but done a gap year as a chef and got far to deep to ever get out alive.... Alsa I am a simple chef

[RustyNut]

you must be a bloody good cook then!