The S2 is dead, long live the S2

[Rikki Kitto]

Just to keep things together wgfv pics

[Rikki Kitto]

Got the missus to coint me down 3.2.1 and managed a 0 to 60 in 6.3 seconds. Hows this for acceleration times any good for a standard car

[Sparky_s2]

Got the missus to coint me down 3.2.1 and managed a 0 to 60 in 6.3 seconds. Hows this for acceleration times any good for a standard car

If the car is only chip-tuned it should be around 5.7seconds. But it of course depends on a whole lot of diffrent factors.

[Rikki Kitto]

Bog standard not even mapped up right yet, just fitted an AAN engine and still getting her right. Can't wait to decat and chip it. My driving skills are rusty too, on a bike most of the time

[andy10v]

According to S2 central 0-62mph

3B coupe 5.7
ABY Coupe 5.9
ABY estate 6.1

[Sparky_s2]

Then your not far from there =)

[Rikki Kitto]

Just good to know the car is running right after the heart transplant, been off the road for a year

[Duffelcoat]

Just good to know the car is running right after the heart transplant, been off the road for a year

Plus it is very hard to match the official figures, you would need very good timing gear and good conditions and do a perfect launch on level ground..

If you are just outside the official time then it is probably about right.

I used a phone app once, not sure if it was any good, but got around 8 seconds (in a C4 A6 TDi quattro I might add!)

[Rikki Kitto]

Well done, I had an Audi A3 TDi nearly beat me from the lights to about 60, nearly committed suicide after that little incident

[Rikki Kitto]

Put some decent clips on the boost hoses today, look and feel much better

[Rikki Kitto]

Finally found what I hope is the last boost leak, after fixing all the hiden ones this was staring me in the face all the time and i kept overlooking it
Amazing what a pinhole size leak can do

[Rikki Kitto]

Went to fit the clutch brace mod and found thisThink the spanner man has made a pattern part fit somehow, looks like somat is missing but seems to work fine for now. Suppose if it ain't broke an all that, I'll leave it until it goes wrong then try get an original part next time

[Error404]

Looks like they've welded a smaller nut to the clevis to enable you to use the earlier 3B / 7A master cylinder.

[Rikki Kitto]

Thought so Oh well I'll leave it ti it goes wrong then fit a proper unit

[Rikki Kitto]

Purely aesthetic engine mods😊 makes me smile anyhoo