Euge's LWB Sport Quattro

[JTK]

Hi, no definitive answer, but I think, and have no grounds to prove I am wrong, it was a defect during production. I can't imagine the Carbon/Kevlar panel would shrink in length and change the curvature of the arch from being stored in a flat for few years...

Anyway, there was some progress in the meantime

[Macchris]

nice improvement :-)
where do u have buy this fiberglass kit panel please ? Thx
Tof

[quattro-nick]

any updates on this car?

[diesel des]

Were did you get the front bumper and grill?

Sent from my LG-H955 using Tapatalk

[JTK]

Hi chaps,

All front panels are from Koraszewski motorsport.

Most recent update:
- got a set of brakes: 323x30mm front with brembo calipers and 300x22mm from S4 B7 of ebay.

- got new set of sport quattro wishbones and ball joints from Albert to fit S2 suspension...
I have a set of sport quattro wishbones for Rallye suspension from Koraszewski motorsport, real shame they don't fit my suspension, if anyone has serious interest I would probably sell it.

- also got front drive shafts made of tank steel from Des

- near finishing off exhaust

currently fighting with the loom, hopefully will fire it up soon

[JTK]

Has anyone tried to fit porsche dashboard in a quattro?

quickly photoshoped it, and can't decide if i like the look of it or not....

[quattro-nick]

now that is going to be a challenge
looks good

[JTK]

Can anyone help me with ignition / starter switch/ ignition lock / wiring to the main engine wiring/ fusebox.

i found female plug on my old KV wiring, but can't find it on the current ABY wiring...


Any help is much much appreciated.

[OrlandO]

Try looking here Aby wiring and here www.kvquattro.com

[Spyform]

nice brakes mate

[JTK]

thanks mate, hope they will stop the car nicely as well.

Just re-read my post above and think I have confused people...

My problem is I can't figure out how starter switch is connected to the main engine harness.

[quattro-nick]

where is your origional wire loom(b2) from steering column,picture maybe?

[ineora]

Sounds like you have removed a bit to much wiring from the car maybe?
There is no connectors that go to the ignition-switch in the 20vt Engine-loom.

In my cq, with 20vt loom, all the wires connect directly to the main fusebox ("CEP"?) and the original Car-wiring takes care of the connection between ignition-switch and the main fusebox.

Note that i also left the original wiring for power-supply to and from generator and starter to main fusebox, thus leading to that i had to swap 2 pins (3 wires?) over from the original black "B"-plug over to the 20vt-looms black "B"-plug when connecting that to the fusebox to get current to the starter.

[JTK]

I have a bare shell, luckily the original loom hasn't been thrown away years ago, thank god managed to find it ( it's a mess).

is there a wiring diagram for this re-pining?

Sorry guys, when it comes to wires I am a complete dummy

[Simons]

you can also take a look to this post

AAN Loom into type 85 Coupe Quattro