Originally posted by UrS4boy
View Post
Announcement
Collapse
No announcement yet.
Small Urs6 project!
Collapse
X
-
You save at least 10 kg when you can to it with one muffler
Extra weight is very bad and mufflers what run straight through do not keep noise down. I don't know what mufflers those are but I am just saying.
I want to make something what lets hp through but noise not Probably impossible But will see.
Comment
-
I went to the shop to buy more paint but the seller suggested different paint. It was also two times cheaper. I don't know whats good or bad.
I will see after few years. I will post photo with new paint bottle later
Here is bottom now.
Attached Files
Comment
-
In the beginning I planned to but bigger muffler but at the end I decided to but this one. Muffler length 60 cm 3'' in and out
Attached Files
Comment
-
Comment
-
What I use.
First coat
This work would be much easier if the car was higher. But no worries, it can be done.
Comment
-
Originally posted by Majorcina View PostNice job
I am also very pleased with the results. It is very dirty job but when it's all done then there is no rust any more. But it is a long way to go. Next month I'll remove gas tank and rear axle. All new Albert's bushings are coming tomorrow.
Comment
-
Comment
-
I did not know that there is plastic and I accidentally cut it half. Luckily I found OEM new one. Bolt is temporary.
Comment
-
Final coat is on. When I start with the rear axle then I can check if everything is coated correctly.
All new rear brake lines also in place.
Little bit of other side also done. The rest of it must wait till I replace gas lines. Hopefully next month
Comment
-
Bought new (someone's old) gas tank. My tank had a tiny hole somewhere and when I putted 044 pump in, then I saw a little rust inside too, new one was ok.
So I cleaned everything and painted also. Used same things as on the bottom.
It is not dry yet.
Comment
Comment