Just out of interest, has anyone had issues with the one way check valve going bad and losing boost as a result?
I have an AAN in my Vanagon Syncro 16 which makes only 11-12psi (chipped ECU) and my brakes are now very hard to work!!
The van has been parked up for a while as we've just moved house but my daily driver Van (Tristar Syncro with 7A) developed a fuel injector body leak so I'm driving the 16 today.
MG
Hydraulic to Vaccum servo conversion
Collapse
This is a sticky topic.
X
X
-
Yes I think you are right on the LHD, but I don't think there is room for a bigger unit on the RHD as the servo is closer to the suspension turret, there is only one size vacuum servo in RHD.
Lets not complicate matters by comparing LHD and RHD parts though
Leave a comment:
-
http://www.ebay.co.uk/itm/2008318148...84.m1439.l2649
I just bought this one from 2000 a4, I am trying to fit it to lhd ur quattro, will see when it arrives.
ThanksLeave a comment:
-
IIRC I heard some where is that the difference between 105A and 107A is the size of it. I have 107A (an inch bigger) one and fits perfectly, but dont know how size affects.Leave a comment:
-
For reference I just bought a vac servo off a 2.0L cabrio with P/N 8A2 612 105 ALeave a comment:
-
-
Here are the pics of the A8 and A4 B6 boosters.
A4 fits. A8 does not fit thru attachment plate and therefore pedal set, as the nose piece dia is too big.
Also note length from firewall to end of master cyl, is shorter on the A4 unit.Leave a comment:
-
I will take a pic or two of the A8 and A4 boosters. A8 should fit with no problem in LHD.
Just very big for RHD where proximity to engine inlet, throttle body could be a problem.
Also, will clarify bolt / attachment layout. Off hand, A4 is bigger diameter but shorter in over all length than the A8, if my memory serves me correctly.Leave a comment:
-
Would you know if a8 rhd sevo would fit lhd car?
I am trying to get all the parts to convert my lhd Ur to vac servo, not sure if local breakers would help me or is better get the stuff from europe.Leave a comment:
-
Audi A8 D2 vac serv is a massive lump. OK for LHD but may be a problem in RHD application.
Any servo such as A4 B6, B5, B3 should be fine.
Just did the pump mod as fitting an AAN to a B3.Leave a comment:
-
power steering pump used: 050145155A ZF
for this you can use the wheel of the ABY/ADU pump as it bolts on the above one, and you need to manufacture a bracket to hold the pump in place. Brian Tonks, did one for me within a few minutes, so not a big deal for those with welding capabilities. Put the 2 pumps side to side and its easy enough.Leave a comment:
-
im not sure, but i got those numbers from people that have done the change themselves.
others have gone for the A8 D2 brake servo. I cannot say which ones will work or not, im sorry. Only experience from others will show that.
A new brake servo from the audi shouldnt be that expensive anyway.Leave a comment:
-
Is it necessary to have that 4a0 612 107A brake booster, or is it possible to do it with 4A0612105P??
BK im not able to fin it in Ebay.....Leave a comment:

Leave a comment: