Just giving an update, got the ECU tested and it wouldnt fire on their car so I am going to hunt down a new ECU. Like an idiot, I probably didnt ground the harness properly the first couple of times I tried to start it
Announcement
Collapse
No announcement yet.
Wiring Masters Needed B3 90q with AAN swap
Collapse
X
-
Congrats!
Comment
-
Originally posted by Durr McDanks View PostGot the the new ECU and she started!!!!!!!! Thank you, thank you, thank you guys for all your help!
That was a lot of pain to get there.
I must say, it did force me to find out about Pin 37 versus the Fuel Pump Relay as a source of power to the injectors, etc. and this resulted in two new FAQ-type posts:
The Holding Relay:
http://forums.quattroworld.com/s4s6/msgs/102009.phtml
and for the injector wiring:
http://forums.quattroworld.com/s4s6/msgs/90802.phtml
So thanks.
Good luck finishing your conversion. Enjoy your 20vt and drive safe.RS2'd 93 UrS4 5 spd sedan
94 UrS4 V8 6 spd manual avant
Comment
-
Originally posted by UrS4boy View PostYAY!!!
That was a lot of pain to get there.
I must say, it did force me to find out about Pin 37 versus the Fuel Pump Relay as a source of power to the injectors, etc. and this resulted in two new FAQ-type posts:
The Holding Relay:
http://forums.quattroworld.com/s4s6/msgs/102009.phtml
and for the injector wiring:
http://forums.quattroworld.com/s4s6/msgs/90802.phtml
So thanks.
Good luck finishing your conversion. Enjoy your 20vt and drive safe.
Comment
Comment