Announcement

Collapse
No announcement yet.

Wiring Masters Needed B3 90q with AAN swap

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • #76
    Just giving an update, got the ECU tested and it wouldnt fire on their car so I am going to hunt down a new ECU. Like an idiot, I probably didnt ground the harness properly the first couple of times I tried to start it

    Comment


    • #77
      Got the the new ECU and she started!!!!!!!! Thank you, thank you, thank you guys for all your help!

      Comment


      • #78
        Congrats!

        S2 Coupe 3B Project


        Ur quattro restoration

        S2 Avant

        Boost is the new rock and roll!
        sigpic

        Comment


        • #79
          Originally posted by Durr McDanks View Post
          Got the the new ECU and she started!!!!!!!! Thank you, thank you, thank you guys for all your help!
          YAY!!!

          That was a lot of pain to get there.

          I must say, it did force me to find out about Pin 37 versus the Fuel Pump Relay as a source of power to the injectors, etc. and this resulted in two new FAQ-type posts:

          The Holding Relay:
          http://forums.quattroworld.com/s4s6/msgs/102009.phtml

          and for the injector wiring:
          http://forums.quattroworld.com/s4s6/msgs/90802.phtml

          So thanks.

          Good luck finishing your conversion. Enjoy your 20vt and drive safe.
          RS2'd 93 UrS4 5 spd sedan
          94 UrS4 V8 6 spd manual avant

          Comment


          • #80
            Originally posted by UrS4boy View Post
            YAY!!!

            That was a lot of pain to get there.

            I must say, it did force me to find out about Pin 37 versus the Fuel Pump Relay as a source of power to the injectors, etc. and this resulted in two new FAQ-type posts:

            The Holding Relay:
            http://forums.quattroworld.com/s4s6/msgs/102009.phtml

            and for the injector wiring:
            http://forums.quattroworld.com/s4s6/msgs/90802.phtml

            So thanks.

            Good luck finishing your conversion. Enjoy your 20vt and drive safe.
            Thank you and I will drive safe. All I have left to do is a complete replacement of my rear brakes. I just finished up replacing all brake lines(rusted) and front rotors/ calipers!

            Comment

            Working...
            X