Intake manifold porsche inscription

[Sonic]

How about S2 forum Corian coasters.

.. and i was just looking to buy some new coasters

[A80Avant]

border S2 you have a pm!

[borderS2]

route

border S2 you have a pm!

and you too
D

[A80Avant]

back at you!

[borderS2]

porsche RS2

Is this what you mean?



It would be better to have a higher res version to work from, or vectors if anyones got them. And exact dimensions for the outer profile.
Dane
(What was I thinking? Coasters, how 1970s! Shouldn't play on the computer after gigs!)

[A80Avant]

yes,more or less.
maybe the porsche letters can have the same height as the rs2 logo,and loose the outside margin,or bring ig down to a hairline...

[madpugger]

Is this what you mean?



It would be better to have a higher res version to work from, or vectors if anyones got them. And exact dimensions for the outer profile.
Dane
(What was I thinking? Coasters, how 1970s! Shouldn't play on the computer after gigs!)

Hey I would be up for coasters!

[borderS2]

More messing

Here's two images
The first shows recessed area in Red




What's the copyright on these logos?
Dane

[madpugger]

If you are not `selling` them, then none

I am no lawyer though!

[A80Avant]

dane,im ok with the bottom one!

[fish]

There is indeed RS2 IM with a "glued on" badge. A mate of mina had an RS2 and we all thought it looked glued on so we took a knife and "peeled" one end up! then we stuck it back on. Would it be possible to make just a alloy plate with that inscription on dane?? If i give you exact outer measurements?? And send it to sweden??

[borderS2]

testing

I'll try a test if i've got time at work tomorrow and speak to the boss about a price... but as we can't sell it to you anyway....
I need exact outside dimensions.
How are you going to fit it on?

Has anyone got a good res image of the RS2 logo?

Does anyone have advice on routing aluminium with <1mm tool, that RS2 logo is damnably small?
Dane

[fish]

Here is a pic of a std RS2 IM.

[fish]

we wont tell anybody were we got it from=)

[borderS2]

Corian

Could do this in 6mm white DuPont™ Corian®, very easily.

http://corian.co.uk/Corian/en_GB/assets/downloads/pdfs/technical/corian_specdata_eng_2008.pdf

Dry heat resistant to above 180C, how hot does the manifold get?
Dane