Intake manifold porsche inscription
Collapse
X
-
Comment
-
I'm interested in one of these. My 90 is "Inspired by PORSCHE [//RS2]" but I can substitute "powered by"
.
I'd like a weld-on in aluminum for my Wagner IM, preferably with an RS2 logo.
PM me if and when available!Comment
-
been way too busy at work. i did play around a little bit the other week. not sure what is going on with jas11n's dimensions, but i have nowhere near that much room on my 3B manifold, so these will be smaller than the dimensions posted previously. i think its at about 1.15" X 11.5" to fit right on my manifold...oh yeah, i think i'm doing the 'powered by audi sport' since i don't have an rs2
i think i'll be painting the recessed areas and likely anodizing the piece...not quite sure yet...
Attached FilesComment
-
My humblest apologises. I've not actually looked at this thread since I posted those dimensions.
I must of typed it wrong

It's 320mm (three hundred and twenty) by 38mm (thirty eight)

I'll have two of the Audi sport versions
Jase..
[sorry
)
2001 Avus Silver B5 RS4.
2004 A4 Avant 1.8T quattro Sport-LE.
1995 S2 Coupe - sold (sniff)Comment
-
Jas11n - "Audi Sport" x 2
A80Avant - "Audi Sport" x 1 (OR if you are making the porsche one,then one of those as well!)
Gavs20v- "Audi Sport" x 1
90/90qs - "Audi Sport" x 1 (OR if you are making the porsche one,then one of those as well!)Comment


Comment