K24R Catch Tanks - Pictures added

[Rusty]

Right then... hopefully I'll be getting parts at the end of the week... don't quote me on that though

[madpugger]

I'll be getting parts at the end of the week

^^^Rusty says they will be here at the end of the week

[Rusty]

[Rusty]

I have tanks! Got to order the hose this week... just waiting for the swirl pots to be done now and we're there 1000 thank yous for your patience people

I've attached a picture of a catch tank and also one of my cheat's swirl pot, that I will be using on my car and on a 3B. These have the head oil feed entering tangentially and also a mesh section, to reduce the amount of oil going to the stock pipe work. They use 1 30mm connecting piece and have a large volume, to reduce gas speed. These can be used with a PCV valve too, should you want to!

[andy10v]

I like the look of that, how much?

[Rusty]

£99 including a short section of 30mm hose to connect to the sump, 8mm hose to sort the N80 out and 5/8" hose to connect to the head. Just needs to be tied into the OE pipe that runs round the back of the head or fed into a catch tank to complete the setup

[Rusty]

Just waiting for the full swirl pots now, I have all the hoses and other parts ready

I did mess up by thinking that the hose was charged at 1.0m lengths and it's 0.5m lengths, so you've all done well there Won't be making that mistake again!

[madpugger]

Woo hoo! Just say if you need more cash mate...

BTW, I just got a cheque from P2G a few weeks ago!

[Rusty]

Bloody hell, they're a bunch of scheisters aren't they! Cheers for the offer

Shouldn't be long now, it's a pretty comprehensive setup , just the sump return that you'll need to sort out yourself, and any special inlet return gubbins that's related to say a reverse IM etc.

[Jamo]

Get my message Rusty?

I'm on and off at the moment due to losing home internet

[Rusty]

Sorry J, PM sent to you today

[Jamo]

Got my tank, i'm very happy with it and it's quality and it's just the right size great job Rusty!

Hopefully find the time and all the bits to install it soon ( somewhere in a box in a garage! )

[Rusty]

It's been a long time comeing... Here's the full kits in black/blue and braided/blue

(The Fumoto valve is not included and the prices are slightly revised from before, due to a mix up with hose costing.)

The kits contain enough hose to connect the crank and cam case breathers to the swirl pot, the sworl pot to the sump and catch tank and the catch tank return feed to the head pipe... as well as pipe to connect the N80 to the head and fixings etc.

I've also attached a picture of the oil separator that I've designed to be used on road/occasional track chipped 3B/ABY & stockish ADU. This is the best 3B solution I currently have and should be suitable for LHD cars too

[Rusty]

Here is the swirl pot in place

[Jamo]

Looking good! , be sure to mention then Rusty that on members with reverse manifolds that swirl pot won't fit in the same location