Clutch kit recommendation 500+ hp setup

[Rocco]

Use the SPEC stage 3+ clutch kit mate.

You'll be happy, good price, confortable and strong

[snp10]

At this time this is my first option.

[Audi_CQ]

SPEC 3+ works fine, but make sure the flywheel is OK/resurfaced and use the clutch without pushing it for a while to bed it in. Read the instructions, and follow them :-)

[newsh]

+1 ^^ took care bedding in with mine and it's been good as gold.

[diesel des]

I think a twin plate clutch of about 8 inch in size with organic material and a pressure plate that holds 500 to 600 ftlb torque would be good for our cars. Should be smoother than a paddle single plate Sachs? There was a place in leeds I talked too who said the could supply something like that for testing....

[snp10]

Maybe in a normal driving , even SRE kit will hold 600 + Nm, but also the are the launches and agressive gearshifting.

[Rocco]

I've a SPEC aluminum single mass flywheel refaced if you need any time

[snp10]

I have a 7a single mass one

[aRtiS]

I have cluch kit for 700+ nm
flywheel also

[Thuppu]

SRE with sinter disc will take 700+ Nm.

[diesel des]

Yep I agree with thuppu. I'm at 700nm on Sachs sre sintered. Holds fine even for fast starts but is agressive.

[snp10]

The disk is the one with 4 pucks?

[diesel des]

Yes. The 4 puck sintered version

[mika.yomaa]

Have someone used Spec 3+ clutch disc with SRE 707 pressure plate?

Could it be used in your opinion? My SRE gave up last time yesterday at the dragstrip. Car used to have +750nm of torque. Billet blingfactory 3b flywheel should work also with that disc...

Lähetetty minun SM-G930F laitteesta Tapatalkilla

[diesel des]

Did the Sachs sintered clutch wear out, or can't it hold the power? I doubt the spec clutch will hold power as well as the sre sintered.

Sent from my Moto G (5) using Tapatalk