My silver RS2 Project

[Tractor Dave]

I've got the little dash ones but not big enough to replace these I don't think bud

Thanks. I have dash ones here and they are smaller. The door card ones are set in a plastic housing that screws onto the speaker cover. Not so easy to replace the speaker internals. I have been trying and its not gone well

[Tractor Dave]

I've done about 200 running in miles now.
It's running nicely but I do have a little coolant leak. I think it's the joint from the thermostat pipe to the hard line pipe that runs down the block.

Of course it's almost impossible to reach now everything is in the way.
I came up with this 7mm spanner with an extension which allowed me to tighten the jubilee clip a turn.


Thanks to Charlie (Cardcrash) here on the forum I have some good rear arch liners. One of mine was damaged. They are a pain to fit and by dropping the top wishbone joint, it was much easier.





That's much better.


Sent from my iPhone using Tapatalk

[Tractor Dave]

Thanks to Newsh I have a replacement fuel sender.


Tank is still a little full to contemplate fitting it just yet.
Some new trims also arrived from Germany. Quality looks good.


And I was missing my wheel brace. A quick check on etka revealed this is a Porsche part. Picked up one from a Porsche breakers for a reasonable price.
They are 19mm which is unusual.



Sent from my iPhone using Tapatalk