Minor update. I've not had time to do anything on the coupe for a few weeks, but today I found a few hours to tie up a few loose ends.
Got the exhaust finished finally. I had to make suitable heat shield for the tunnel, as there is only around 20mm clearance against the centre section.
I used one of my old 7A shields, but it needed quite a bit of persuasion to make it fit
With the exhaust fitted:
Little stainless bracket on the prop bearing to support a stiff exhaust hanger. These are great, next to zero movement in the exhaust:
Lower chassis brace fitted, and all done:
Hoping to get the interior all refitted tomorrow and driveshaft spacer finished tomorrow. Then I just need to finally sort out my prototype adjustable PAS pump and should be ready for a quick road test & then MOT
Got the exhaust finished finally. I had to make suitable heat shield for the tunnel, as there is only around 20mm clearance against the centre section.
I used one of my old 7A shields, but it needed quite a bit of persuasion to make it fit
With the exhaust fitted:
Little stainless bracket on the prop bearing to support a stiff exhaust hanger. These are great, next to zero movement in the exhaust:
Lower chassis brace fitted, and all done:
Hoping to get the interior all refitted tomorrow and driveshaft spacer finished tomorrow. Then I just need to finally sort out my prototype adjustable PAS pump and should be ready for a quick road test & then MOT
Comment