My 95 S2 Avant Project. LZ5T Coolness

[irishs2]

Just note that it's a non abs mc, although its a tandem mc like the s2, I am unsure of the difference between that and the s2 abs one.

[afterburner]

Well, I need a bigger MC than the one I have now - which is a black steel tube one found on a B4 80q that presumably is 23.81mm. I have my ABS system removed completely, so technically I'm without ABS I guess that one from the transporter, if it fits the vacuum assisted servo on a B4 80q, will be a perfect bonus to my bigger than stock front and rear caliper pistons?

[irishs2]

Seems perfect so.

[Error404]

BTW Eric where did you get the new boot for the linkage balljoint I thought there were NLA?

[audinut]

absolutely amazing work going on here ! where did you get those red coil packs !

[irishs2]

I thought they were NLA too, but to my surprise they weren't, so I ordered 3 of them. €11+vat


I got the coils from ebay.de auction with the loom , about two weeks before Alex started making his looms ..doh!

[irishs2]

Got this in the post this week
Should eliminate a common point of failure.


Before I could start what I wanted to get done today, the tank had to come off again so I could properly sort out the fuel return. As well as fit the new cap.



Tank reinstalled, I fitted my B5 RS4 heat shield (RS2/s2 is NLA). It only needed slight modification and it fitted.

Part number for those interested.


New nuts bolts etc.


Bambridges tie bushes


Bambridges solid mounts. These took some fitting, as the tolerance is very tight and the POR15 had to be sanded back so they could fit.




Rear end is up and mostly attached. Just need to torque it up tomorrow.





New brake line fitted.


And front to rear brake line.

[audinut]

yay thats what the back end of mine looks like underneath :-) wish i had thought of that heat shield though

[irishs2]

More NLA business. This one annoyed me, and they tend to rot on all avants. There are no equivalent B5 Rs4 shields either.




So I decided to make one.


I think this shield came from an A6. Got it very cheap.. NLA guilt and all that.


I wrapped the old shield shield in a black bag, put it into a box big enough and rested it on some standoffs.
I then sprayed this stuff underneath it and waited



After waiting a few days for to to cure, I cut the excess foam and was able to extract the shield leaving the bag in contact with the foam.



Hammertime.



Copypasta



Installed

[audinut]

HA HA that is very clever !!!

[mcandmar]

Copypasta

Is there no end to your creativity. Bravo Sir.

Seriously though i'll take one

[audinut]

thats 2 then...

[A80Avant]

Count me in! I have no idea how mine is at the moment

[audinut]

actually can i have your old rusty one?

[irishs2]

I need to make one more for the rs2 down the line, and will need to make a top mold , it is very poor and thin barely holds it own weight and the right side is rusted trough, but if you still want it I am sure we can work something out.

Lol