Sleeper S2 Avant +400HP

[Jonas_R]

...

[M_GORDON]

Not sure they are MK2. They are from an Audi S6 C5 17x8" ET35.

Mk2. Sure.
but if you are happy, we are happy

Hahahahaha

[Jonas_R]

Not sure they are MK2. They are from an Audi S6 C5 17x8" ET35.

[M_GORDON]

ñah! mk2... INMO mk1 looks better

[Thuppu]

They look very nice!

[Jonas_R]

Got my rims back from power coating today: rim1.jpg

Mounted on the car - They are really close to the outer edge at the fender, but think they look nice: rim2.jpg

[M_GORDON]

RS2 dials with standard bulps

FINE!
I probed my ABY dials with normal lamps and the light is too "amber" for me, and with red leds the light isn't to homogeneous

[Jonas_R]

RS2 dials with standard bulps

[M_GORDON]

IMG_20180604_150404928_LL.jpg

Standard dials with standard bulbs?

[Jonas_R]

So had some time today and got my RS2 AUX gauges installed. Thumbs up to s2_bo for that nice guide found here.

Going out.
IMG_20180604_092146134.jpg

RS2 AUX gauge ready to go in, nice and white.
IMG_20180604_092501775.jpg

Final installation shot:
IMG_20180605_210346790.jpg
IMG_20180605_201751349.jpg
But I did manage to sort out the problem with my RS2 speedometer where half of the lights was off. Apparently the PCB had an error, swapped it out with the PCB for my S2 speedometer and lights again.
Now I just need to find the problem on the broken PCB. But really nice that I can see what speed i'm driving at, at night.
IMG_20180604_150404928_LL.jpg

[Jonas_R]

I'm trying to make this kit so you can install a 2 din radio. But only in the drawing stages at the moment.

Still Cold and snowy here in Denmark so no driving yet.

[macspring]

Lovely work.

Any news ?

[Jonas_R]

So here is my fake MAF

Milled of heat sink finns:


Heat sink reinstalled:


Made a small latch to close the holse where the sensor element was:


Installed latch:



Good as new, sort of

[Jonas_R]

So I have now installed VEMS and got it mapped some what decent to 0.9 bar before it went into winter storage.

I have started operation fake maf so it will still look stock.

So disassemble the maf and milled of the heat sink.

More pictures to come.

For the people using VEMS can the unit be mounted in the same place as the motronic?

[Jonas_R]

Bought it from eBay.de