80q b4 2.2 20vt project

Collapse
X
 
  • Time
  • Show
Clear All
new posts

  • Thuppu
    replied
    Kiitos! Yes it was like that, except the heat shield(fitted it today, made of 1mm stainless). He didn't say anything about it, he was just looking at it with big eyes.

    Leave a comment:


  • Filip_FIN
    replied
    Congrats on the katsastus

    Did the screamer pipe were like that when you were in katsastus?

    Leave a comment:


  • Thuppu
    replied
    This car is so fun! Have been driving a lot and everything seems to work fine. Seems to turn many heads even as the looks is like an basic 80. Maybe the violent sound has something to do with it haha...1st and 2nd gear wot between some buildings, screaming wastegate, bangs and some turbo shatter is quite effective attention-getter.

    Leave a comment:


  • Thuppu
    replied
    Originally posted by M2ki
    In here you can use ABY as comparison.
    Yes, could be possible here also. Only you need to use same body/chassis(sedan) as comparison. Not many here in finland, and our car database didn't know the ABY sedan. Also everything needs to be like the comparison car. This has lowering springs, they would need to be proved to S2 sedan. Not many spring kits has this approvement.

    Leave a comment:


  • M2ki
    replied
    In here you can use ABY as comparison.

    Leave a comment:


  • Thuppu
    replied
    We used stock AAH 174hp as comparison so +20% is max leagal power figures on street.

    Leave a comment:


  • Henkjan
    replied


    Originally posted by Thuppu
    MOT:ed today without any faults, and the car is now registered as 5 cyl turbo quattro. Official power is 202hp/270Nm(dyno sheet with these figures).
    why so modest?

    Leave a comment:


  • Thuppu
    replied
    MOT:ed today without any faults, and the car is now registered as 5 cyl turbo quattro. Official power is 202hp/270Nm(dyno sheet with these figures).



    Leave a comment:


  • quattro-nick
    replied
    looks great thomas,mot okay now?

    Leave a comment:


  • diesel des
    replied
    Nice!

    Sent from my Moto G (5) using Tapatalk

    Leave a comment:


  • Thuppu
    replied


    Leave a comment:


  • Thuppu
    replied
    Honestly I don't know, but I would guess it would hold for some time, especially when the ring is now pressed down tight between the wg and manifold flanges. If it doesn't hold, then I could try to make one from stainless.

    Leave a comment:


  • diesel des
    replied
    I wonder if it will last ok in this application?

    Sent from my Moto G (5) using Tapatalk

    Leave a comment:


  • Thuppu
    replied
    Just basic mild steel.

    Leave a comment:


  • diesel des
    replied
    What material did you use for the valve seat?


    Sent from my Moto G (5) using Tapatalk

    Leave a comment:

Working...