Originally posted by s2_bo
View Post
Originally posted by s2_southwest
View Post
Originally posted by s2_southwest
View Post
I'm not going to be beaten though. Not by a set of headlamps.
You can't get in from behind either. The removable cap over each bulb isn't big enough to get inside at the workings.
So, how the hell do I get in?
I'm going in through the bottom. I've cut out a section of the case, well not cut but sliced with a red hot blade so as not to get crap, dust and rubbish inside.
I need to get at two very small screws to remove them. Once removed, the plate used for beam cutout (which is metal and stamped LHD) and is sandwiched between the projector and it's framework, can be slid out turned round and slid back in. That done it'll have the beam pattern reversed from LHD to RHD.
Once happy, I'll plastic weld the bottom up.
I've got to make a small 90° right angle pozidrive with a 3mm thick handle to get at the screws.
Expect to get this sorted after work tomorrow afternoon, will of course take lots of pictures to show what all that gobbledegook above means
As said before, where there's a will there's a way
Comment