K24R Catch Tanks - Pictures added

[Rusty]

YEah, you should be fine, as it sits above the crank case breather outlet. The only thing I can think of is the tank hitting the inlet but this can be easily solved with a little insulative material.

[Jamo]

Any updates?

[Rusty]

Hi all, a quick update on this. I have been told that I'll be getting the tanks at the end of next week - the bank holidays and a personal holiday have played havoc with it all.

Jamo, yours will be the first to go out and I will be getting the rest of the kits put together and sent out as soon as I can.

Many thanks for everyone's patience...

[Jamo]

Give me a tinkle or message before you send it out bud, i'll explain when you get them

[Rusty]

OK, coolio

[M_GORDON]

One question Rusty:
Don't U have any problem with the smoke?

I have one little tank with a hose directly to the down of the engine and the smoke can see around the car

Thanks.

[Rusty]

If you're venting the tank to the atmosphere, then it can smoke. All these kits are designed to feed back to the inlet

[M_GORDON]

If you're venting the tank to the atmosphere, then it can smoke. All these kits are designed to feed back to the inlet

Yours too?
I just see a minifilter.

[Rusty]

Ah OK, that picture was taken to show what you could do, hadn't even seen that it had a filter on it. I don't run mine like that and haven't had a request for a vent to atmosphere tank in over 18 months. All the tanks for this buy are return to inlet, so no smoke or fumes under the bonnet

[M_GORDON]

OK but yours are for RHD not?
The hoses and the tank's holes must be different not?

[Rusty]

I don't have a LHD tank design at the mo and the RHD one would not work on a LHD car.

[Rusty]

Just an update on this - the tanks are still in production and delivery has been delayed a little due to the glut of bank holidays and also a few production challenges that had to be overcome. Fingers crossed they'll all be sorted very soon... I can only apologise for the delay but this is out of my hands at the mo, as I'm the designer and not the fabricator.

[Jamo]

Are they done yet?

Thanks for keeping us all updated Rusty

[Rusty]

Yeah, sorry mate... hope it's not long now.

[Jamo]

I was joking bud dont worry we appreciate the effort and update