034 Short Shift

[poor-boy]

I have received only 6 sets But all six can be offered if someone's interested

P.S. I hope all buyers are satisfied.

Not yet fitted but the quality so far looks good

[M_GORDON]

Excuse me, too much work an too low energy
On May 1 I mount mine.

Not plugand play at all.

I pass much time adjusting the OEM gear block system but the worst was when I been putted the OEM spring and the space to the mechanism was low not, missed.

Why that I been cutted the plastic piece and now the gear knob can goes down to gear reverse

[quattrostyle]

It was known that the 6-speed needed mods to fit. Does it work now?

[M_GORDON]

It was known that the 6-speed needed mods to fit. Does it work now?

YEESSSSS
Perfectly and is a

[quattrostyle]

stop messing about and try to say what you mean in an understandable way.

[M_GORDON]

stop messing about and try to say what you mean in an understandable way.

[|CL|NIKI]

New group buy?

[DeS]

New group buy?

I've got 6 sets ready if there's interest.

[bobis2]

hello ok for the france ?

[DeS]

Everyone's invited. I can shipp worldwide.

[M_GORDON]

This wednesday probe the car and the Short Shift is AWESOME

[Tom_]

where belongs this alloy pad?And how much cut off a plastic "thing"?





this belongs down?


and 4 pieces of spacers come where?Because on the studs it doesnt fit

[zefsider]

Tom,

Slice a little bit of the black plastic at the end that is nearest to you so that the alloy fits into the hole ....it needs a bit of fiddling around to get it flat but it will go in, I managed it even after a night of being totally drunk ! ....the washers were too small for the studs on mine too, but you don't need 4, just get 2 slightly bigger ones....sorry I forgot to take pictures of my fit ....good luck tovarich,

[Tom_]

Are u mean this?



so spacers i need only two,and need to little bit redrill...

[zefsider]

I don;t think you really need the 2 alloy plates, just one would do, its only to give a firm base for the balljoint piece , I put both on only because it would make it a stiffer base....and yes, just a craft knife to carve a little bit off the plastic surround so as to drop the alloy plates into the hole...it will covered up by the gearstick gaiter anyhow, so will not be visible...its a bit hard to explain, but its just a case of jiggling it all about until it is firmly sited, then bolt it up with a couple of washers that ere bigger diameter centre than the ones supplied ( only a little ) bit bigger