New S2 Avant Nothelle N300 owner

[Tractor Dave]

I didn't need the ratchet strap. I had to cut the bolts off the joint clips at the front. A quick spray of wd40 and it moved forward in the joints another 2 inch. Perfect fit now. It must have hung out a lot on it's previous car

[Tractor Dave]

Good plan. Cheers John.

[newsh]

Yes!
It was quite easy to fit but it's slightly too long at the moment. I need to check all the joins are fully home.

They tend to hit the rear valence when hot! Stainless expands a lot.
I used a ratchet strap to pull the centre joint together, get some tension on it then bang it with a rubber mallet.

[Tractor Dave]

Man there's so much more room under an avant compared to a coupe!

Yes!
It was quite easy to fit but it's slightly too long at the moment. I need to check all the joins are fully home.

[Bowie69]

Man there's so much more room under an avant compared to a coupe!

[Tractor Dave]

Milltek fitted. I need to order two new hangers before I can take her for a spin.



Sent from my iPhone using Tapatalk

[Tractor Dave]

Looked lovely in the flesh , I was parked on the same row but very near the end , unfortunately wasn’t able to put a name to the face ?

We need another get together before the summer is gone

[simons2]

Looked lovely in the flesh , I was parked on the same row but very near the end , unfortunately wasn’t able to put a name to the face ?

[Tractor Dave]

Arriving at AITP



Sent from my iPhone using Tapatalk

[Tractor Dave]

As I do not have a Tig welder, popped over to see my mate. A small section of the Milltek had been cut off as they apparently could not get the joint apart.
I need to learn this skill.


I can’t wait to hear that lovely 5 pot warble.


Sent from my iPhone using Tapatalk

[Tractor Dave]

Quite right! It was the bargain of the year

[Ian Simmonds]

That's worth few quid, I hope you did not pay too much.

lol… It’s Dave…

[robo]

That's worth few quid, I hope you did not pay too much.

[Rikki Kitto]

Good gamble

[Tractor Dave]

I saw an advert for an unknown make RS2 exhaust and downpipe. Took a chance but it was cheap. Got it home and it’s only a genuine downpipe and full cat back 3” Milltek!




I need to do a small repair then it’s going on.


Sent from my iPhone using Tapatalk