Announcement
Collapse
No announcement yet.
New S2 Avant Nothelle N300 owner
Collapse
X
-
Well, I have driven a few miles with the Milltek and there is some annoying drone at certain revs.
I think it might be my de cat pipes.
Anyway, I happen to come by a good set of RS2 cats (as you do)..
A quick clean up before fitting.
And just about to fit and this happened. Why always on a Bank holiday weekend!
Sent from my iPhone using Tapatalk
Leave a comment:
-
Innuendo Corner.
I’ve just popped out with the tape measure and mine is exactly 2 inches at the top.….
Leave a comment:
-
Just measured mine. Now 2” proud of bumper. Before adjustment it would have been 4”!
I will be listening my old exhaust for sale if anyone is interested. It’s in very good rust free condition.
Sent from my iPhone using Tapatalk
Leave a comment:
-
Hmmm, interesting. Our 3” Miltek.
certainly not flush, but not 2” out either.
Leave a comment:
-
I didn't need the ratchet strap. I had to cut the bolts off the joint clips at the front. A quick spray of wd40 and it moved forward in the joints another 2 inch. Perfect fit now. It must have hung out a lot on it's previous car
Leave a comment:
-
Originally posted by Tractor Dave View Post
Yes!
It was quite easy to fit but it's slightly too long at the moment. I need to check all the joins are fully home.
I used a ratchet strap to pull the centre joint together, get some tension on it then bang it with a rubber mallet.
Leave a comment:
-
Originally posted by Bowie69 View PostMan there's so much more room under an avant compared to a coupe!
It was quite easy to fit but it's slightly too long at the moment. I need to check all the joins are fully home.
Leave a comment:
-
Milltek fitted. I need to order two new hangers before I can take her for a spin.
Sent from my iPhone using Tapatalk
Leave a comment:
-
Originally posted by simons2 View PostLooked lovely in the flesh , I was parked on the same row but very near the end , unfortunately wasn’t able to put a name to the face ?
Leave a comment:
Leave a comment: