My 3B to RS2 project

[newsh]

My 3B to RS2 project

Had a word with Doug at ADI. I will get Mihnea to do it I think, but may wait till I fit new head, either that or Jonus..
Have to say it's running pretty nice on the Mihnea RS2+ fuel chip and eBoost street [emoji41][emoji41]

I have to be careful with the boost though or it pings..

[Error404]

Cool. Must admit I am considering the Maxx ECU

[LHD_Kid]

I knew you were having issues with the Prj chipset but thought you got it sorted?
You're still mafless?

[LucheS2@20v]

Cool. Must admit I am considering the Maxx ECU

One guy with diesel stroke 700hp have some problems with maxx ecu and go for kms md 25

[newsh]

I knew you were having issues with the Prj chipset but thought you got it sorted?
You're still mafless?

No, MAF is back in.

[LHD_Kid]

Hmmm... I can see me having to drive from Brussels all the way up to Automark to have mine mapped after the problems you had... bit worried now myself about what to do...

[newsh]

Hmmm... I can see me having to drive from Brussels all the way up to Automark to have mine mapped after the problems you had... bit worried now myself about what to do...

What's the spec of your car Chris?

[LHD_Kid]

I'll send you a pm John - not going to dilute your project thread with red....

[newsh]

I'll send you a pm John - not going to dilute your project thread with red....

Ok cool, I was probably nearly there with the PRJ mafless tune but I didn't have the patience to keep driving it and tweaking the maps. I still have the ECU and injectors here, if I could get Dmitri to come over and sit in the car he could probably finish it in an hour..

In fact I might even burn the fuel chip and try it with the boost controller

[newsh]

Cool. Must admit I am considering the Maxx ECU

Well I've been spending a bit of time with Ish and his boys and I've been seduced..

[newsh]

Finally found my phantom water leak, been bothering me for a while as I kept wondering if the head gasket was going..
Turned out to be the heater pipe take-off on the back of the block.




I contacted Andy and he sent me over one of his K24R anodised spigots. Job done and no more leak.

[newsh]

Relayed my fuel pump

[Error404]

I think you're supposed to connect the wires up to a relay mate

[newsh]

My 3B to RS2 project

I think you're supposed to connect the wires up to a relay mate

to you too [emoji12]

See how fat those wires are though eh?

[Error404]

Did you go for 2.5mm? Can't quite see from the pics. Have you still got the battery up front mate?