My AAN 2.2 20v Turbo B5 A4 Avant build

[Sleeper_Avant]

wont be as low as it was peter, defo defo defo 100% making it look very very "sleeper"

might have to tint the windows a smoke tint so you cant see the single bucket though, other than that its 1.6 badges, no bonnet pins or chopped up bumpers and 16" steel wheels (banded ofcourse!) all the way

nobody will suspect a thing MWUHAHAHAHAHA!

[Acidburn]

Sounds good, still going for a cage?

and you want 1.8 se badges (did they do 1.6 a4's?)

as 1.8t/1.9 tdi badges would put people off, both cars can be made to go quicker with enough money chucked at them

[Sleeper_Avant]

they did 1.6 A4`s, yes.............. now imagine how slow they are

didnt want 1.8 badges as the T could have fallen off/been removed

TDi, well, never trust a TDi lol! every

no cage yet, but will sort one when its a rolling project with a few other bits and pieces

like strip the sound deadening out, fit the cage and polycarb windows......... all can be done while the car is running and being used
not like ive got to take anything out to do this is it lol!

will be staring front mounted radiator and STD fuel tank for now too
will be using a non chopped up A4 front pannel and Rad (with the heavy+sh1tty boost pipe/support brace cut out)
and my standard fuel tank(still has my 044 pump fitted, obviously.)
again, all can be done while the car is mobile

[Sleeper_Avant]

i do however want to try and locate some keep-fit windows for the front, im SURE they did them in eastern europe, but cant find any details in english language

any ideas folks?

[Acidburn]

keep fit windows are going to be a pita to locate in this country, don't think we got them, could try butcher some 80 one's to go in from a boggo spec tdi 80 avant, swap the mech over.

[sam80quattro]

http://vagcats.info/base/au/3/1199/156/8/10458

[sam80quattro]

they do exist but as pete says probably difficult to find

crikey, whilst checking the 80 parts to see if they even looked the same i found this..
Door trim
/ for weapons-grade box
for Submachine Gun

[Acidburn]

probably in that 1.6 slowmobile

[Sleeper_Avant]

might take the motor off and see if i can just make something fit it

saying that, the doorcards actually need to be in place for the door seals, with them removed theres a 1/2inch gap from the door to the seal...........
i can see this being a right b1tch

well i wouldnt expect anything else on my car lol!

[Sleeper_Avant]

cheers Sam,

im actually gonna rin the dealers to try and buy some tomorow i think

[Acidburn]

depends how noisy you want the car.

Stumpy's track day s4 has poly windows and thats quite noisy inside

[Sleeper_Avant]

looking on Ebay, the B6 rear manual winder seems to bolt into the same 3 bolt holes as the electric motor............ that could be handy

http://www.ebay.co.uk/itm/Audi-A4-B6...item27ca000024

[Sleeper_Avant]

Peter, has stumpys car got doorcards on it?

[Acidburn]

nope

[Acidburn]

This is his car (minus the mental carbon bonnet)

http://audisrs.com/about42138.html