K24R 300mm / 314mm budget rear brake upgrade

[Rusty]

Bit of a hiccup with this as I've had to find a new source for the brackets etc.

[Rusty]

Brackets and spigots have arrived!

[Rusty]

Bosh

Discount to the first person who spots the deliberate mistake.

[Kieron20V]

Threaded the wrong holes? Hub caliper lug side should be straight thru and brackets should be threaded for caliper.

Sent from my HTC One X+ using Tapatalk 2

[Rusty]

Nope, both brackets are correctly made

[twoqu]

The spigot doesen't have a chamfer!

[Rusty]

It does, it's just on the other side

[diesel des]

Not properly sided?

Sent from my GT-N7105 using Tapatalk 4

[Rusty]

It's a very simple thing. There's even a clue nearby...

[Kieron20V]

Theyre made out of hard anodized mdf?hehe.

Sent from my HTC One X+ using Tapatalk 2

[twoqu]

The hole spacing is @5mm larger on the right one!

[Rusty]

Correct enough! They're different brackets. Clue was in the title

10 points to Robin.

[Rusty]

I was a bit concerned about strength given the bracket dimension requirements, so over engineered these somewhat... they're beastly They're also rather lighter than they would have been in mild steel

Can't wait to get all my toys fitted.

[re2500]

Hehehehe I'm getting all giddy!!

[re2500]

302mmmmmmmm's

Giggadee...