K24R Catch Tanks - Pictures added

[Rusty]

Just getting to this now...

Jamo - ABY
HPMuirt - ABY
Sonic - ABY

s2driveruk - 3B

4wheeldrifter - custom

keithsw0 - ?

s2belgium - LHD ABY

[Rusty]

Any more for any more?

I'll be getting the designs out for quote tomorrow.

[GazzaG60]

got any pics. i may well be interested here.

pm me if its not public domain.

[Rusty]

Very similar to the tank below. Can do vent to atmosphere (shown) or inlet return designs. The new tanks are updated to include extra baffling and increased volume. If you've got anything sat next to the ABS unit then you'll need to move it.

As these are made to order, I can change inlet and outlet sizes and positions (19mm is standard, the inlet return top outle sits angled at 30deg towards the strut brace). I will be running a separator idea that I have but you could easily run 30mm from the crank case and 19mm from the head and then fit a sump return (the boss on the base is oversized to 1.5" so it can be drilled and tapped to most outlet sizes).

[Jamo]

Is mine custom to the above because of the pipework for the separator input, or is it just you have to specify a different angle and the body is the same as the aby?

[GazzaG60]

i like it andy. i think it should just fit in nice in mine too.

maybe this is already posted but ballpark cost?

cheers

[Rusty]

For the new standard design, £90-100 for the tank and mounting bolts, £100-120 for one with customised inlet / outlet.

[GazzaG60]

its that plug and play , hoses included or to use stock hoses

if so count me in.

[Rusty]

As I buy the hoses retial, I'll recommend what hoses you require and leave it up to you what brand / quality you get. So hoses not included...

[GazzaG60]

no worries. can you supply lengths though for aby positioning (im sure you can)

[Rusty]

Yup, it's about 1m of 19mm pipe for a stock car - ~40cm from the ABY union pipe to the tank and then use most the remaining 60cm to run along the strut brace. To connect to the OE head through pipe is a bit of a pain as it's 22mm but the 90deg piece is 19 in 22 out so that could be utilised with a straigh connector

For higher powered cars I'd recommend going a bit more custom (see the thread I'm about to write )

[GazzaG60]

ok andy ill wait for the thread.

cheers

[Rusty]

Head Breather Pipe Investigations Thread.

[Rusty]

Have just heard back from my alloy fabricator, can't start these until next year. I'll speak to another supplier and see what's what and update the thread when I have something...

[andy10v]

How much would you be looking at for a swirl pot Andy?