RichLV's UrS4
18z brake swap is fully prepped on parts department. All that is needed now is a rebuild of the calipers themselves. Sourcing pistons was a bit of a challenge, but I got it done. Calipers should be done during this week, luckily, swap will be done on Saturday. Calipers may prove a bit of a handful, since I had most of the pistons seized.
For the parts I picked:
- Full Frenkit seals & pistons kits
- Zimmermann 4.2 C6 (347x30) rotors
- Ferodo 17z brake pads
- HEL braided black brake lines
- TRW pad hardware
- TRW wear sensors
18z brake swap is fully prepped on parts department. All that is needed now is a rebuild of the calipers themselves. Sourcing pistons was a bit of a challenge, but I got it done. Calipers should be done during this week, luckily, swap will be done on Saturday. Calipers may prove a bit of a handful, since I had most of the pistons seized.
For the parts I picked:
- Full Frenkit seals & pistons kits
- Zimmermann 4.2 C6 (347x30) rotors
- Ferodo 17z brake pads
- HEL braided black brake lines
- TRW pad hardware
- TRW wear sensors
Comment