Announcement

Collapse
No announcement yet.

Another "Stroker" Project

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Nothing special....

    I am collecting parts for the SWB-Project and will reverse the RS2 (convert it back to stock specs as all the changes I did are fully reversible).
    Go Holset or Go RS4

    Comment


    • Which injectors you finally used? Bosch 750 ? What about FPR and fuel rail? Is there any chance to fit these injectors (750 or 1300) directly to 3B rail? Or there is any adapters ?Thank you, nice project
      Audi Coupe Quattro 2.3 20V

      Comment


      • Originally posted by Billman View Post
        I had an leak on the oil pressure check valve and a very low idle at 750.
        Bill on AAT block is oil pressure check valve too? I thought that only on petrol engines (ABY,AAN,ADU). Where is located?

        Thank you
        Audi Coupe Quattro 2.3 20V

        Comment


        • Hi, what oil pressure valve do you mean? In the block for the oil path to the head?
          Go Holset or Go RS4

          Comment


          • Yes in the engine block, near to water thermostat housing...
            Audi Coupe Quattro 2.3 20V

            Comment


            • Yes, you use there a check valve so that the hydro tappets don't "rattle" on engine start. The one on the AEL engine was different than the ADU one.
              Go Holset or Go RS4

              Comment

              Working...
              X