A couple of the finished engine bay. You can see the fuel lines that I built with replacement poly coated steel lines that are a dead ringer in appearance for the factory lines. I'm happy with the result, but it was a pain to do in steel. The first set of lines I made without the engine in the car. I waited until the engine was in to cut and flare the ends where they mate with the lines from the fuel rail. While trying to flare the last line my flaring tool slipped and goofed the flare. I cut the damaged end off and went to try again, but the line was not long enough for me to put the fitting on and get the tool on the end of the line. I cut the entire line out of the car and started over. This time with the engine in the car. I failed at least 6 times and got so angry I had to walk away from the car for weeks at a time between tries.
20230117_204522.jpg
20230117_204541.jpg
20230117_204522.jpg
20230117_204541.jpg
Comment