VEMS I5 Maps

[murat]

I am trying to load the RS2 file in the first post with V3 16x14 High-boost profile and it is generating some warnings in audit log.

What am I doing wrong?

[Carfreak]

I am trying to load the RS2 file in the first post with V3 16x14 High-boost profile and it is generating some warnings in audit log.

What am I doing wrong?

Do u have the right vemstune/megatune and firmware ?

[Billman]

Do u have the right vemstune/megatune and firmware ?

This is a very old Firmware file for Megatune.

[murat]

My car is on service right now. I am trying to get used to vems. I bough a VEMS in 2009 and never installed. Right now I want to install it. I am just playing with software. And of course a basemap for stock RS2 helps.

Any maps foor newer firmware?

[spions]

Does someone have stock configuration for AAN or ABY.
I put fuel pump on VEMS output pin 15 for v3 but still not starting.

[murat]

have you tried default aan config from vemstune?

[spions]

Couldn't find default aan
I had 1.1.27 and on it fuel relay was working.
No on 1.1.95 no

[murat]

If you are using newest vemstune, it shoud be in

Tools -> Firmware -> config upload

please validate config after uploading(Tick icon in toolbar)

If you want I can send an ADU config for 1.2.2

sometimes some values need changing by hand

[murat]

See attached screenshot for audi config upload

also please check if your output channels are selected right/wrong?

Can you hear the pump working when you turn the ignition on?

If you are hearing the pump, then also check your trigger settings. Sometimes small mistakes happen.

[spions]

No pump is not working . I have plug&play v3 but on vemstune it shows econseal typ so I dont know wich pin is for fuel relay.
It would be great if you could send adu config.

[murat]

No pump is not working . I have plug&play v3 but on vemstune it shows econseal typ so I dont know wich pin is for fuel relay.
It would be great if you could send adu config.

I also use PNP,

Screenshots are my config, so it should be same with yours. The software shows econoseal, dont care about it.

I am attaching a config for 1.1.94
So there could be different things.

If you need I also can attach a 1.2.2 config if you need

[murat]

Please check if your fuel pump output is inj channel 5, also check it should not be inverted.

Also validate config to see if there is any invalid config entries.

[murat]

Please send your config if these are not enough so we can check also your config

[spions]

tnx working

[murat]

What was the problem for future ref?