This is the sensor that came with ECU? But there is nowhere I can screw it in the reducer? There is also a nipple in the ECU kit but same there, nowhere to put it. 
-
'93 Audi 100 Avant - R.I.P
'92 Audi UrS4 Avant - SOLD
'93 Audi UrS4 Avant
'15 Audi A7 quattro 3.0 TDI -
Remove that bolt in you vaporisor that's between the 2 water connections and screw that sensor in.
Sent from my LG-H955 using TapatalkComment
-
I removed the plate and there are 2 holes in there?
Last edited by hunker7; 9 March 2016, 19:27.'93 Audi 100 Avant - R.I.P
'92 Audi UrS4 Avant - SOLD
'93 Audi UrS4 Avant
'15 Audi A7 quattro 3.0 TDIComment
-
...'93 Audi 100 Avant - R.I.P
'92 Audi UrS4 Avant - SOLD
'93 Audi UrS4 Avant
'15 Audi A7 quattro 3.0 TDIComment
-
Threads match ok?
Sent from my LG-H955 using TapatalkComment
-
Good lad
Sent from my LG-H955 using TapatalkComment
-
This is the connector that came with the plastic hose, so I need to flare it in order to fit it to tank/reducer?
'93 Audi 100 Avant - R.I.P
'92 Audi UrS4 Avant - SOLD
'93 Audi UrS4 Avant
'15 Audi A7 quattro 3.0 TDIComment
-
It should measure 6 or 8 mm od. You then use a compression fitting in it just like you would with copper.
Sent from my LG-H955 using TapatalkComment
-
Something like this?
'93 Audi 100 Avant - R.I.P
'92 Audi UrS4 Avant - SOLD
'93 Audi UrS4 Avant
'15 Audi A7 quattro 3.0 TDIComment
-
Tighten that fitting into the tank valve and it should compress the olive and then when you remove it it should become one piece.
Sent from my LG-H955 using TapatalkComment
-
When will you fit it? Sooner it's running the sooner you save money for a bigger turbo 😀
Sent from my LG-H955 using TapatalkComment
-
Cool. Seems you are doing this but I wood put it all together on the floor and make sure you have all you need. Take a picture once that's done and I will have a look. You have the gas pressure and intake pressure sensor right? Also the gas switch and gauge?
Sent from my LG-H955 using TapatalkComment
Comment