Originally posted by steve briance
View Post
Announcement
Collapse
No announcement yet.
New S2 Avant Nothelle N300 owner
Collapse
X
-
A bit more progress today.
I haven’t found those plastic cowls yet so I’m pressing on for now.
Exchange alternator fitted
Intercooler fitted and making up the mount for the oil cooler
My air box seems to be missing something as the maf won’t directly fit. Horrible cone for now.
Sent from my iPhone using TapatalkNothelle S2 Avant
Black Ur project
Ocianic Ur project gone
S2 Coupe project gone
Urs6 plus project gone
Comment
-
Originally posted by Rikki KittoHave you done the Mark H mod on the intercooler?
Sent from my iPhone using TapatalkNothelle S2 Avant
Black Ur project
Ocianic Ur project gone
S2 Coupe project gone
Urs6 plus project gone
- 1 like
Comment
-
Originally posted by Tractor DaveWhat’s going on with the front engine mount? Am I missing something?
The rubber bush doesn’t seem to contact anything.
Sent from my iPhone using Tapatalk
What I mean is there is no contact between the half moon bracket that the aux rad sits on and the rubber bush on the front engine mount. I checked on 7Zap and don’t appear to be missing anything.
Sent from my iPhone using TapatalkNothelle S2 Avant
Black Ur project
Ocianic Ur project gone
S2 Coupe project gone
Urs6 plus project gone
Comment
-
Ok. Thanks again.
Also I seem to have a spare oil return hole not being used. All of the turbo oil lines are connected.
It’s the one on the sump extension to the rear of the oil filter. Again, apologies but not a very good picture!
Oil cooler pipes all fitted nicely.
Filled the cooler with oil.
It’s gone very damp outside so I did some paint drying in the house. Don’t tell the Mrs!
Sent from my iPhone using TapatalkNothelle S2 Avant
Black Ur project
Ocianic Ur project gone
S2 Coupe project gone
Urs6 plus project gone
Comment
-
The turbo oil drain goes to a different place if you have AC, the AC pump bracket fits over the hole in the block.
Ask me how I know this
Rusty will remember
Comment
-
Originally posted by newsh View PostThe turbo oil drain goes to a different place if you have AC, the AC pump bracket fits over the hole in the block.
Ask me how I know this
Rusty will remember
So, what would be best now? Swap the return hose over and fit the AC bracket to cover the return or just blank off the hole I have now?
Thanks JohnNothelle S2 Avant
Black Ur project
Ocianic Ur project gone
S2 Coupe project gone
Urs6 plus project gone
Comment
-
Originally posted by Tractor Dave
Now I understand. I've deleted the air con as all the parts were missing. I didn't replace the bracket and as your turbo already had the pipes attached it was a straight bolt on fit. That explains why I now have a spare return oil pipe and a hole in the sump extension.
So, what would be best now? Swap the return hose over and fit the AC bracket to cover the return or just blank off the hole I have now?
Thanks John
Comment
-
Originally posted by Tractor DaveOk, thanks John. I will figure it out tomorrow. Perhaps just fabricate a simple blanking plate from some left over 5mm Aluminium
Comment
-
Originally posted by newsh View Post
That’s what I did, only the other way round and I used 3mm steel I thinkNothelle S2 Avant
Black Ur project
Ocianic Ur project gone
S2 Coupe project gone
Urs6 plus project gone
Comment
Comment