New S2 Avant Nothelle N300 owner

[LSG]

Dave I know this may sound daft but have you put new bulbs in your clocks and checked they work .

[Tractor Dave]

Dave I know this may sound daft but have you put new bulbs in your clocks and checked they work .

No

I will now. I have had to take it all off again. I forgot to fit the vents pipe Now I'm drinking beer

[Greg_S]

I guess that’s the challenge with having all the hits but not taking it apart yourself. Also make sure cables are taped so you don’t get rattles too

[Tractor Dave]

I guess that’s the challenge with having all the hits but not taking it apart yourself. Also make sure cables are taped so you don’t get rattles too

Yes. Gone through two rolls already!

[Bowie69]

Clip heater bowden cables as well,took me months and months to find one of them rattling against the clutch/brake pedal bracketry!

[Tractor Dave]

Very slow progress
Not sure how to start connecting those heater cables and the wires all at the same time!




Sent from my iPhone using Tapatalk

[M2ki]

It is easier if heater cables are in place. Maybe even impossible if some of the flaps cables have been disconnected from the heater flaps.
Remove all the knobs, 2 screws hold the heater faceplate, then underneath 4 screws hold the heater plate to the center console.
Install in that order: heaterbox with cables-> dashboad-> screw in the center console-> screw in the heater plate> heater faceplate, knobs.

Center console also has 4 screws for mounting, you mast remove the air guides to access the top screws, lower screws hide behind the heater faceplate.

[Tractor Dave]

It is easier if heater cables are in place.
Remove all the knobs, 2 screws hold the heater faceplate, then underneath 4 screws hold the heater plate to the center console.
Install in that order: heaterbox with cables-> dashboad-> screw in the center console-> screw in the heater plate> heater faceplate, knobs.

Center console also has 4 screws for mounting, you mast remove the air guides to access the top screws, lower screws hide behind the heater faceplate.

So you mean fit the Bowden cables to the heater box first then bring the control box in and fit cables to it?

[newsh]

So you mean fit the Bowden cables to the heater box first then bring the control box in and fit cables to it?

Yes
Heater box with cables and all the controls can be fitted as one lump.

[M2ki]

Remove the control box from center console, connect bowden cables to heater box, verify that all the flaps move correctly, then install dash.
Check these two videos.

https://www.youtube.com/watch?v=8uhDzfLd8Ns

https://www.youtube.com/watch?v=s8hDi-VfrPo

[newsh]

Although your heater box is already in.
Definitely fit the cables and controls to it before anything else goes in under the dash.

[Tractor Dave]

Thanks. I will have a go tomorrow. Drinking beer again now

[newsh]

That won’t help

[M2ki]

Dont remember if you can remove the lower part which directs air to the floor without removing the heater box completly. Two bowden cables go between those two parts. Two other bowden cables are easy to fit.

[Tractor Dave]

Dont remember if you can remove the lower part which directs air to the floor without removing the heater box completly. Two bowden cables go between those two parts. Two other bowden cables are easy to fit.

Now I'm really depressed