My 3B Coupe project - Total rebuild

[A80Avant]

That's a small turbo...

[Rocco]

wow Andy

what are you doing?

you passed a great sunny sunday i see....


i hope everything is OK

[AndyP]

That's a small turbo...

It to be so it doesn't break the clutch!

[AndyP]

wow Andy

what are you doing?

you passed a great sunny sunday i see....


i hope everything is OK

Well it'd be no fun if you just drove it all the time, you have to pull it apart once in a while!!

[AndyP]

Well that's a bit of a blow, looks like the engine could be scrap

After the crank re-grind I fitted the new bearings and torqued up the main caps. The No. 4 bearing had somehow become crimped and was damaged. After fitting another set, I could only get to 40lb/ft on the mains before the crank become stiff and at 65lb/ft it locked up. Afte taking some measurements off the block is seems the block is bowed in the middle, meaning the main caps are ovaled, no. 4 being the worst. JP still has the cranks to see if that is salvagable, if not I'll be starting again.

P**sed off is an understatement

[Jamo]

Say it aint so!!! I was just looking for this thread to find out how things were going

[Tonks4x4]

Oh mate, that is ****!!!! Just go for standard ABY bottom end and get some enjoyment...


Tonks4x4 - The Land Rover Specialist

[Error404]

Have you had the main alignment checked? You might be able to get the block align honed. ARPs do crush the mains slightly, so if your mains are out of alignment it won't take much to eat all your clearance.

[AndyP]

Oh mate, that is ****!!!! Just go for standard ABY bottom end and get some enjoyment...


Tonks4x4 - The Land Rover Specialist

I was going to put my 3B engine back together and throw that in, but it needs about £400 worth of parts and then I'd have mess around getting the down pipe to fit.

I do have a spare AAT bottom end, but I'm just finding it hard to get motivated to do it all again!

[AndyP]

Found out what the problem was with number 4 main bearing





One small bit of good news is that the crank has been checked and is OK. Just need to start work on another block. FML

[A80Avant]

Maybe these blocks can't take the abuse

[Error404]

****! Never seen that before on an I5 - whats the history on that block?
At least you've got to the bottom of that and the crank is good. Did you find out what the oil consumption issue was?

[DNA-S2]

I feel for you mate !



Danny
DNA Autocare Ltd

[Ross]

Gutted for you, was looking forward to an update here!

I know how it goes... I've parked the RS2 because I can't be done with dropping the sump on my driveway at the moment! Think I'd take a bit of time out, gather bits, then hit it when you get the motivation.

[Jamo]

Jesus H!!!!!!!!!!!!