Project: RS2 ABY

[s2_bo]

Congrats guys, im sure everyone involved is very pleased indeed. We need some video footage now Andy!

[Sonic]

I know, i can't believe i didn't take my camera with me... will get some soon

[Jamo]

If you got the pump from Terrybullwon it's likely a 10 bar one he had some 5 bars as well, if you could see the outside numbers you could tell
Your oil cooler is a setrab oil cooler
Congrats on the results now when do I get a shotgun ride

[Sonic]

If you got the pump from Terrybullwon it's likely a 10 bar one he had some 5 bars as well, if you could see the outside numbers you could tell

Yeah i got it from James a while ago now, maybe that explains it after all then!

Your oil cooler is a setrab oil cooler

Congrats on the results now when do I get a shotgun ride

Cheers, just need to have a dyno shoot-out now with a few of the other forum big-boys

You'll have to get your *** down this way again and have a ride, that or whenever the next meet is. Or you can come to the ring on 16th August

[prj]

To be fair, I think it does shoot flames out of the exhaust with 15 ATDC ignition timing...
Only one way to find out.

Also, MAC valve was not causing a boost leak. These cars just don't boost properly at higher power setups with them, even at 100% duty cycle (signal on all the time).
Probably something to do with the restrictor size or lack thereof in it, but I don't really care, as the standard N75 is more than good enough.

Also Andy, you should take all the cr*p out of your car and try sitting in there alone for a change. It'll be lots faster then.

[djh]

Also Andy, you should take all the cr*p out of your car and try sitting in there alone for a change. It'll be lots faster then.

There are a few forum members who should take your advice. Cars run a lot quicker without carrying around the contents of most people's houses

[Sonic]

To be fair, I think it does shoot flames out of the exhaust with 15 ATDC ignition timing...
Only one way to find out.

Lol I can certainly vouch for that

Also Andy, you should take all the cr*p out of your car and try sitting in there alone for a change. It'll be lots faster then.

There are a few forum members who should take your advice. Cars run a lot quicker without carrying around the contents of most people's houses

if felt pretty damn fast as it was! And I didn't hear you complaining about sitting in the electric rs2 leather recaros

There is a bit of crap in the boot, duck tape, cable ties, wheel jack etc but that's about it. If I stripped the car any more I think I'd only go and make it heavier again with a roll cage. Part of the fun in having a comfy street sleeper car as it stands.

I could get some decent alloys though, that would save a **** load of weight!

[Acidburn]

Glad you've finally got it sorted, if you get bored at will's tomorrow pop down to bahnstorm as me and error will be there, its around 5-10 mins from vrs

There is a bit of crap in the boot, duck tape, cable ties

what is it about forum members carrying rape kits with them at all times, error was on about this in another thread as well

[Sonic]

Glad you've finally got it sorted, if you get bored at will's tomorrow pop down to bahnstorm as me and error will be there, its around 5-10 mins from vrs

I wasn't planning to be at wills tomorrow unless the car is good to go tomorrow evening.

There was a problem with the alarm going off after we installed the new chips, but hopefully it was just a blip which was cleared by killing the power.

what is it about forum members carrying rape kits with them at all times, error was on about this in another thread as well

What can i say... We always like to be prepared.

And don't forget the jack, to crank them open!

[Ross]

Glad you've finally got it sorted, if you get bored at will's tomorrow pop down to bahnstorm as me and error will be there, its around 5-10 mins from vrs



what is it about forum members carrying rape kits with them at all times, error was on about this in another thread as well

Did he have his gimp mask in the back too?

Seriously impressive results Andy, a bit of motivation to get mine back on the road now you're running! Just too damn busy with work at the moment

Acidburn didn't complain about the extra weight in the back seat during my mapping session...

I probably don't speak only for myself when I say there's going to be a request to Will for an RS4 MAF and intake hose set-up modded to fit an RS2 airbox... where do I sign?

[Acidburn]

Did he have his gimp mask in the back too?

Seriously impressive results Andy, a bit of motivation to get mine back on the road now you're running! Just too damn busy with work at the moment

Acidburn didn't complain about the extra weight in the back seat during my mapping session...

I probably don't speak only for myself when I say there's going to be a request to Will for an RS4 MAF and intake hose set-up modded to fit an RS2 airbox... where do I sign?

Wish I had more time, the s2 avant was cut in half today so that took a while.

Extra weight - the cheek

[Greg_S]

Excellent news on finally getting properly sorted. What spec is the turbo you are using aside from being a K26/27#8?

[Sonic]

That's a good question

[re2500]

We need pics/videos or the flames didn't/don't happen!

[europeanme]

nice one Andy...so chuffed you have got it sorted and the way you wanted it...with 500hp the trips to the blue monsoon won't take you long at all!!.....