Project: RS2 ABY

[prj]

Lol have you ever been to the lake district? Not many tunnels

Yep alright now, afr was 13.5 on cold startup which seems better as well.

That sounds correct, as mapped.

Curious how it will run on full boost, and if the boost issue and running rich at WOT is solved now.

Also, 4" of snow, you sissy. We had -30C today in the morning never mind the snow...

[driftin jo]

get to the M6 and get your foot down

[Sonic]

yeah but you have proper tyres I bet!

Problem over here isn't that the s2 wouldn't get out - it would - but you wouldn't get 10 yards before some idiot drove into the side of you.

People over here are scary when there is a bit of snow on the ground!

[twoqu]

At least it sounds encouraging! We can have the post mortem discussion once its running properly.
Does sound like the cam/timing was a factor though.

[prj]

Agreed, if it suddenly does not go as rich and boosts, then definitely something wrong with the cam setup.
I have trouble believing MRC would set that up wrong though.

[twoqu]

It sounds like thay set it up to RS2 spec, but of course that would only be correct if all the relevant RS2 components had been used I guess. Then there is the adjustable cam pulley!

[Ross]

Eagerly awaiting new on this Andy... hoping at least the fuelling is sorted, that really is the oddity here I think. Boost is likely then down to WGFV or WG. Both can be tested when we get a bit of time. But let's hope it is all sorted!

Conditions are pretty horrid out there, went up the shops earlier and kissed a kerb with 1/2 turn of opposite lock - expected a bit of rear end action but not quite that close... had to blast past an M3 poor sod was really struggling

[newsh]

Sounds encouraging

Do you know what was going on with the lifters??

[chezz]

People over here are scary when there is a bit of snow on the ground!

They sure are...

http://www.youtube.com/watch?v=NDRwZ4Pf9rM

[newsh]

They sure are...
http://www.youtube.com/watch?v=NDRwZ4Pf9rM

Dude, that's dark..

[Sonic]

Made it home.

6th gear pull 3-5krpm, 21psi, 11.5 AFR.

Group 0 on vagcom all looked perfect on idle, and compression on all cylinders is good.

Didn't get to try the waste gate, that trick is next.

[prj]

A bit too rich and lacking a bit of boost.
I wonder if that could be a leak somewhere.

Have you tried spraying down the injector seals with soapy water?
Also, could you actually post your Group 0 log? I'll decide if it's perfect or not

[Sonic]

Forgot to say will be doing vagcom and zt2 logs next week now I have everything.

[Ross]

That seems alot better. I make that 1.45bar so you are still down about .4bar and comparing to the log on my thread i think 12 is about as rich as you should see at that boost.

I'd swap that WGFV out after Newsh's experience, then WG, and get the soap spray out. To double up jubilee clips on the turbo outlet and IC in/out might not be a bad idea either.

[Billman]

very nice. This boost pressure is with N75 or still with MAC valve?